Avaya DEFINITY Server CSI, Руководство по обслуживанию, Страница: 1401 / 1930

MMI-BD
Issue 5 October 2002
1401
555-233-119
Table 365. TEST #6 TSI Crosstalk Test
Error
Code Test
Result Description/Recommendation
ABORT Internal system error. This is an abnormal abort.
1. Retry the command at 1-minute intervals a maximum of 5 times.
1002 ABORT The system could not allocate time slots for the test, the traffic load on the
system is very high, or the time slots are out-of-service due to TDM-BUS
errors. Refer to
‘‘TDM-BUS (TDM Bus)’’ to diagnose any active TDM Bus
errors.
1. If the system has no TDM-BUS errors and is not handling heavy traffic,
repeat the test at 1-minute intervals a maximum of 5 times.
1003 ABORT The system could not allocate a tone detector for the test. The system is
oversized for the number of tone detectors present, or some tone detectors
are out-of-service.
1. Resolve any ‘‘TTR-LEV (TTR Level)’’ errors in the Error Log.
2. Resolve any ‘‘TONE-PT (Tone Generator)’’ errors in the Error Log.
3. If neither condition exists, retry the test at 1-minute intervals a maximum
of 5 times.
2000 ABORT Response to the test was not received from the MMI-BD circuit pack within
the allowable time period.
1. If this result occurs repeatedly, attempt to reset the circuit pack if the
other ports are not in use. Reset the circuit pack by issuing the busyout
board PCSS, reset board PCSS, followed by the release board PCSS
commands.
2. If this result occurs again, replace the circuit pack.
2012 ABORT Internal system error. This is an abnormal abort.
2100 ABORT Could not allocate the necessary resources to run this test. This is an
abnormal abort.
1. Retry the command at 1-minute intervals a maximum of 5 times.
FAIL The TSI was found to be transmitting in error. This causes noisy and
unreliable connections.
1. Replace the circuit pack.
PASS The TSI is correctly using its allocated time slots.
Continued on next page