Avaya DEFINITY Server CSI, Руководство по обслуживанию, Страница: 1676 / 1930

Maintenance Objects
1676
Issue 5 October 2002
TDM Bus Clock Parameter Update Test (#151)
This test updates the following internal parameters on the Tone-Clock circuit pack:
■
Disable in-line duplication status messages.
■
Set the PPM threshold at 85 PPM for TN2182.
■
Enable PPM threshold switching
■
Set the number of slips to trigger loss of signal - currently 30 per 5
millisecond period
■
Enable the on-board synchronization switching algorithm (see above)
■
Enable holdover operation (TN2182 only).
This is not a test and will always pass without identifying or reporting any
Tone-Clock circuit pack errors
TIE-BD (Tie Trunk Circuit Pack)
Refer to ‘‘XXX-BD (Common Port Circuit Pack)’’ Maintenance documentation for
circuit pack level errors. See also ‘‘TIE-TRK (Tie Trunk)’’ .
Table 493. TEST #151 TDM Bus Clock Parameter Update Test
Error
Code Test
Result Description/ Recommendation
ABORT Internal System Error
FAIL Internal System Error
1. Retry the command at 1-minute intervals a maximum of 5 times.
PASS The Tone-Clock circuit pack parameters have been successfully updated.
Continued on next page
MO Name (in
Alarm Log) Alarm Level Initial Command to Run
1
1. Where P is the port network number (1); C is the carrier designation (for example, A, B, or C); and
SS is the address of the slot in the carrier where the circuit pack is located (for example, 01, 02, etc.).
Full Name of MO
TIE-BD MIN test board PCSS sh Tie Trunk Circuit Pack
TIE-BD WRN test board PCSS sh Tie Trunk Circuit Pack