Avaya DEFINITY Server CSI, Руководство по обслуживанию, Страница: 1660 / 1930

Maintenance Objects
1660
Issue 5 October 2002
Procedure 1 (Nondestructive)
Execute the Idle Time Slot Test (#294) by issuing the command test tdm P when
the control channel is on the same TDM Bus as it was when the circuit pack
entered the reset state. If using this method is not feasible, try the other
procedures in this section.
Procedure 2 (Nondestructive)
if you are at the site: Reseat the circuit pack. This action causes the circuit pack
that was in the reset state to begin functioning on the current Control Channel
bus.
Procedure 2 (Nondestructive)
Execute the Idle Time Slot Test (#294) by issuing the command test tdm P when
the control channel is on the same TDM Bus as it was when the circuit pack
entered the reset state. If using this method is not feasible, try the other
procedures in the section.
Procedure 3 (Destructive)
Reset the port network that contains the circuit pack that is in the reset state.
When a network is reset, two restart messages, one on the control channel of
each TDM Bus, are sent to each circuit pack on the network. Executing the reset
system L command (where L=2, 3, 4, or 5) resets all networks in the system.
!
WARNING:
The reset system command disrupts all calls in the system.
Procedure 4 (Destructive)
Execute the recycle carrier PC command where P is the Port Network Number of
the network containing the circuit pack and C is the designation of the carrier
containing the circuit pack.
!
WARNING:
This command removes power and returns power to the designated Medium
cabinet port carrier. Thus, any other circuit packs on this carrier is also
temporarily taken out-of-service.