Avaya DEFINITY Server CSI, Руководство по обслуживанию, Страница: 645 / 1930

ANL-24-L (24-Port Analog Line)
Issue 5 October 2002
645
555-233-119
Conference Circuit Test (#7)
This test verifies that the NPE channel for the port being tested can correctly
perform the conferencing function.
Table 39. TEST #7 Conference Circuit Test
Error
Code Test
Result
Description/Recommendation
ABORT Could not allocate the necessary system resources to run this test.
1. Retry the command at 1-minute intervals a maximum of 5 times.
1000 ABORT System resources required to run this test are not available. The port may be
busy with a valid call. This result is also reported for the system’s
Music-On-Hold port when it is off-hook, which it usually is.
1. Use display port PCSSpp to determine the station’s extension.
2. Use status station extension to determine the service state of the port.
3. If the port is in use, wait until the port is idle and retry the command at
1-minute intervals a maximum of 5 times.
1004 ABORT The port was seized by a valid call during the test. The test has been
aborted.
1. Use display port PCSSpp to determine the station extension.
2. Use status station to determine the service state of the port.
3. If the port is in use, wait until the port is idle and retry the command at
1-minute intervals a maximum of 5 times.
1005 ABORT The test was aborted due to a configuration problem. This test may not be
applicable, or it may be disruptive to terminal equipment other than a voice
terminal (for example, the modem pool member or Music On Hold).
1018 ABORT The test has been disabled via administration. The default for the Test field
on the Station screen is y. Determine why this field has been set to
n
for this
station. It may be due to application Test #48, which can disturb users or
terminal operations.
1. To enable the test for the station being tested, enter change station
extension and set the Test field to y.
2000 ABORT Response to the test request was not received within the allowable time
period.
2100 ABORT System resources required to run this test are not available.
1. Look for TONE-PT errors in the error log. If present, refer to “TONE-PT”.
2. If there are no TONE-PT errors in the error log, retry the command at
1-minute intervals a maximum of 5 times.
Continued on next page