Avaya DEFINITY Server CSI, Руководство по обслуживанию, Страница: 673 / 1930

ANL-LINE (8-Port Analog Line), ANL-NE-L (8-Port Neon
Analog Line)
Issue 5 October 2002
673
555-233-119
1008 ABORT Could not allocate a ringing circuit for one of the following reasons:
■
All the ringing circuits are in use, or
■
The ringing generator is defective, or
■
It is not wired correctly.
1. Retry the command at 1-minute intervals a maximum of 5 times.
2. If the test continues to abort, look for RING-GEN errors in the Error
Log. If an ABORT 1008 occurs for Test #48 on other circuit packs as
well, the ring generator may be defective. If it does not occur on other
ports, that circuit pack is currently using all 4 ringing phases.
1018 ABORT Test has been disabled via administration. The default for the Test field
on the Station screen is y. Determine why this field has been set to
n
for
this station. It may be due to application Test #48, which can disturb users
or terminal operations.
1. To enable the test for the station being tested, enter change station
extension and set the Test field to y.
2000 ABORT Response to the test request was not received within the allowable time
period.
2100 ABORT System resources required to run this test are not available. Either a
system allocation to get information about the port or to put the port into a
service state failed or the attempt to put the port in connection with a tone
source failed (this could be a tone-clock problem). The tone-clock and tone
detectors could be having a communication problem, for example, the
companding modes could be out of synchronization.
1. Retry the command at 1-minute intervals a maximum of 5 times.
FAIL The terminal equipment is not connected to the circuit pack or the ringing
generator may have failed.
1. Remotely test the equipment.
2. If the test fails again, look for RING-GEN errors in the error log. If
present, refer to the RING-GEN (analog ring generator) Maintenance
documentation.
3. Check all of the wiring between the station equipment and the switch,
and run the test again.
4. If the test still fails, the set may be defective. Check the set, and
replace it, if necessary.
5. Some terminal equipment (such as a modem) could fail even when it is
connected properly. If this is the case, use change station extension
and enter n in the Test field to disable the test. This also disables tests
6, 7, 161, 47, and 35 on this port in some systems.
Table 49. TEST #48 Station Present Test — Continued
Error
Code Test
Result Description/ Recommendation
Continued on next page