Avaya DEFINITY Server CSI, Руководство по обслуживанию, Страница: 692 / 1930

Maintenance Objects
555-233-119
692
Issue 5 October 2002
1004 ABORT A valid call seized the port during the test and aborted the test.
1. Use display port UUCSSpp to determine the station extension.
2. Use status station extension to determine the service state of the
port.
3. If the port is in use, wait until the port is idle before testing. Retry the
command at 1-minute intervals no more than 5 times.
4. If the test continues to abort, escalate the problem.
1005 ABORT This test was aborted due to a configuration problem. The test is not
applicable for this type of analog port. This error can be ignored.
1018 ABORT Test has been disabled via administration. The default for the Test field
on the Station screen is y. Determine why this field has been set to
n
for
this station. It may be due to application Test #48, which can disturb users
or terminal operations.
1. To enable the test for the station being tested, enter change station
extension and set the Test field to y.
2000 ABORT Response to the test request was not received within the allowable time
period.
2100 ABORT System resources required to run this test are not available.
1. Retry the command at 1-minute intervals no more than 5 times.
2. If the test continues to abort, escalate the problem.
FAIL The reflective Looparound Test failed. This could cause noisy or unreliable
connections, or users calling this port may hear an echo. The problem can
also be off-board.
1. Since a line seizure may affect the test, repeat the test at 1-minute
intervals for no more than 5 times.
2. Use test board UUCSS short to run circuit pack tests to check the
tone generator and the tone detector circuit packs.
3. Resolve any problems on the tone generator or the tone detector
circuit packs.
4. If the tone generator and tone detector circuit packs are functioning
properly, determine if a voice terminal is connected and wired properly.
Resolve any problems found.
5. If the test still fails, replace the analog line circuit pack.
PASS The port provides an analog transmission path to the station equipment.
Investigate user-reported troubles on this port by running other port tests,
by examining station wiring, or by inspecting the station.
Table 55. TEST #161 Looparound Test — Continued
Error
Code Test
Result
Description/Recommendation
Continued on next page