Avaya DEFINITY Server CSI, Руководство по обслуживанию, Страница: 472 / 1930

Maintenance Commands
555-233-119 472
Issue 5 October 2002
Field descriptions
Dial-out number
Numbers that are dialed out by administered connections for each
channel in the call. The dial Out #1 and #2 on page 1 of the forms
display the DCP endpoint number. This is particularly useful with
bonding dial-out calls.
Connection
State
The call state of the AC. The following are connection states
associated with dial-out ACs:
“enabled” = Transient in nature indicating that an AC is about to enter
the “attempting to connect” state.
“disabled” = one of three options:
■
The AC reaches an administered retry threshold, and all retries
are stopped. To verify this, check the Error Log to see if an error
type of
9
is logged against the AC.
■
The AC is in a connected state with the far end disconnected.
■
The initial channel call is not connected. No dial out call attempt is
made for the additional channels until the initial channel has
reaches a connected state.
“not scheduled” = Transient in nature, indicating that an AC is about to
enter the “attempting to connect” state.
“waiting to retry” = The AC is inactive, waiting for the retry timer to
expire. Once the timer expires, the AC sends a dial out call and enters
the “attempting to connect” state. In this state, dial out calls fail at
least once.
“attempting to connect” = The AC is active, but has not connected.
“connected” = The call associated with the AC is answered and joins
cut-thru to the conference.
Retry Count
Tallies the attempted retries for this AC during join attempts and does
not clear when the AC connects. However, it clears when the Redial
feature attempts a new join. This differs from the
Join Count
which
counts the number of times the channel joins the conference during
this conference session.
Failure Cause
An ISDN or CPTR cause value (values lower than 0x7f) records when
the last dial out call drops. Values above 0x7f are generated
internally.
Table 26 on page 473 lists all possible failure cause values
displayed by this field and its associated description. The
Failure
Cause
value logs in the Error Log and displays with the display
errors command. (
Err Type
is normally displayed as a decimal.)