Avaya DEFINITY Server CSI, Руководство по обслуживанию, Страница: 1228 / 1930

555-233-119
1228
Issue 5 October 2002
1005 ABORT Configuration for this test is incorrect.
Verity that the link is in-service with the status port or status link
command. Verify that the routing table has destinations that are
reachable through this port.
Repeat the test.
If the test aborts with Error Code 7, while step 1 verified, escalate the
problem.
1125 ABORT Link is not in service.
Check if the link is in-service or not. If the link is not in service,
release the link using release link or release port command and
repeat the test. This is a normal abort.
If the test continues to abort after following the repair procedures,
escalate the problem.
2000 ABORT Response to the test was not received from the CLAN circuit pack
within the allowable time period.
If this result occurs repeatedly, attempt to reset the circuit pack if the
other ports on the board are not in use (Yellow LED is off). Reset the
circuit pack by issuing the busyout board UUCSS, reset board
UUCSS, and release board UUCSS commands.
If this result occurs again, replace the circuit pack.
2012 ABORT Internal system error.
Retry the command at 1-minute intervals a maximum of 3 times.
2100 ABORT The necessary system resources to execute the test could not be
allocated.
Retry the command at 1-minute intervals a maximum of 5 times.
2500 ABORT Internal system error.
Retry the command at 1-minute intervals a maximum of 3times.
2800 ABORT No CLAN in the same region.
Verify translations and retest.
2801 ABORT No IP address defined.
Verify translations and retest.
Table 280. TEST #1387 H.323 Signaling Group Ping Test — Continued
Error
Code Test
Result
Description/ Recommendation
Continued on next page