Avaya DEFINITY Server CSI, Руководство по обслуживанию, Страница: 649 / 1930

ANL-24-L (24-Port Analog Line)
Issue 5 October 2002
649
555-233-119
Station Status and Translation Audits and
Updates Test (#36)
This test updates the analog port’s message lamp state (if it has one) and
translations with information in the software.
Table 41. Test #36 Station Status and Translation Audits and Updates
Error
Code Test
Result
Description/ Recommendation
ABORT Could not allocate the necessary system resources to run this test.
1. Retry the command at 1-minute intervals a maximum of 5 times.
1004 ABORT The port was seized by a valid call during the test. The test has been
aborted.
1. Use display port PCSSpp to determine the station extension.
2. Use status station to determine the service state of the port.
3. If the port is in use, wait until port is idle and retry the command at
1-minute intervals a maximum of 5 times.
1005 ABORT The test was aborted due to a configuration problem. This test may not be
applicable, or it may be disruptive to terminal equipment other than a voice
terminal (for example, the modem pool member or Music On Hold).
1006 ABORT This port has been busied out by command, or taken out-of-service by the
failure of the NPE Crosstalk Test.
1. Look in the Error Log for error type 18 (port busied out) for this port. If
this error is present, use release station extension to release the port,
and run the test again.
2. Check the Error Log for error type 1025 (NPE crosstalk test failed) for
this port. If this error is present, investigate the errors associated with
the NPE Crosstalk Test #6.
3. Make sure that the terminal is connected and in service and retest.
2000 ABORT Response to the test request was not received within the allowable time
period.
2100 ABORT Could not allocate the necessary system resources to run this test.
1. Retry the command at 1-minute intervals a maximum of 5 times.
1 FAIL This does not indicate a hardware problem. The switchhook audit failed. The
other updates were not performed because of this failure. This may occur
when the audit is performed at the same time the terminal equipment goes
off-hook.
1. Use status station to determine when the port is available and retry the
command at 1-minute intervals a maximum of 5 times.
Continued on next page