Avaya DEFINITY Server CSI, Руководство по обслуживанию, Страница: 1107 / 1930

DS1-BD (DS1 Interface Circuit Pack)
Issue 5 October 2002
1107
555-233-119
Table 232. TEST #143 Minor Alarm Inquiry Test
Error
Code
Test Result Description/ Recommendation
ABORT Internal system error
2100 ABORT Could not allocate the necessary system resources to run this test.
1. Retry the command at 1-minute intervals a maximum of 5 times.
2000 ABORT Response to the test was not received within the allowable time period.
This may be due to hyperactivity. Error type 1538 in the error log
indicates hyperactivity. The hyperactive circuit pack is out of service and
one or more of the following symptoms may be exhibited.
1. The DS1-BD tests (such as test 138 and test 139) are aborting with
error code 2000.
2. The tests run on the ports of this circuit pack are returning a no board
result.
3. A busyout or a release command has no affect on the test results.
4. A list config command shows that the circuit pack and the ports are
properly installed.
NOTE:
When hyperactivity occurs, the circuit pack is isolated from the
system, and all of the trunks for this circuit pack are placed into the
out of service state. The system will try to restore the circuit pack
within 15 minutes. When no faults are detected for 15 minutes, the
DS1 interface circuit pack is restored to normal operation. All of
the trunks for the DS1 interface circuit pack are then returned to
the in service state. Hyperactivity is often caused by the
associated facility. In such a case, faults (such as slips, misframes,
or blue alarms) would be entered in the error log. In addition, many
hardware errors would be logged against the associated trunk
circuits. If the facility is OK and the error occurs again after 15
minutes, escalate this problem.
Continued on next page