Avaya DEFINITY Server CSI, Руководство по обслуживанию, Страница: 1019 / 1930

DIG-IP-STN (Digital IP Station)
Issue 5 October 2002
1019
555-233-119
Digital Terminal Audits Test (#17)
This is a series of tests that are classified as audits. The SPE sends messages to
the softphone application or IP Phone to perform the following tests. These audits
run only if the station is in-service.
■
Switchhook Inquiry Test
—
This is an update of the SPE records according
to the softphone switch hook state.
■
Ringer Update Test
—
This updates the softphone ringer state according
to the processor records.
Table 196. TEST #16 DIG-LINE Station Lamp Updates Test
Error
Code Test
Result
Description/ Recommendation
ABORT Internal system error
Retry the command at 1-minute intervals a maximum of 5 times.
1 ABORT This port could have been busied out by system technician.
Look in the Error Log for Error Type 18 (port busied out) for this port. If this error
type is present, then release the port via the release station <extension>
command and run the test again.
Make sure that the terminal is connected.
Retry the command at 1-minute intervals a maximum of 5 times.
3 ABORT Station could be in ready-for-service or out-of-service state.
Use status station command to verify state of station.
Make sure the terminal is connected.
Retry the command at 1-minute intervals a maximum of 5 times.
1000 ABORT System resources required to run this test are not available. The port could be
busy with a valid call.
Use display port UUCSSpp to determine the station extension of the port. Use
status station to determine the service state of the port. If the port is in use,
wait until the port is idle before testing.
If the port status is idle, then retry the command at 1-minute intervals a
maximum of 5 times.
FAIL Internal system error
Retry the command at 1-minute intervals a maximum of 5 times.
PASS The message to light all of the station lamps was sent successfully to the port.
Continued on next page