Error Code Manual Chapter2. Bill Recycling Machine (BRM)
2-160
© 2014
Nautilus Hyosung Inc.
All Rights Reserved.
Code
Problem Description
Troubleshooting
560F400
GM004 motor removal error
during Withdrawal Ready.
1. Open the lower unit
2. Check the knob rotates in the Mid
Transport Path(20)
3. Check the notes and substance
inside of the Mid Transport Path
4. Check the sensor GS023 status
560F500
Decreased encoder count of
GM001 moter less than
previous values during
Withdrawal Ready.
1. Operate to initialize BRM(Recovery)
560F600
Decreased encoder count of
GM002 moter less than
previous values during
Withdrawal Ready.
1. Operate to initialize BRM(Recovery)
560F700
Decreased encoder count of
GM004 moter less than
previous values during
Withdrawal Ready .
1. Operate to initialize BRM(Recovery)
560G100
Failure to 3 Way Gate 0
degree mode conversion
during Withdrawal Ready.
1. Open the upper unit
2. Open the CSM and TE(12)
3. Remove notes and substance from
the gate in the Rear Transport Path
560G200
Failure to 3 Way Gate 120
degree mode conversion
during Deposit Count during
Withdrawal Ready.
1. Open the upper unit
2. Open the CSM and TE(12)
3. Remove notes and substance from
the gate in the Rear Transport Path
560NC00
Failure to check the last note
at the termination of mid
transport path during
Withdrawal Ready.
1. Operate to initialize BRM(Recovery)
2. Reboot the system when same error
occurred (message timeout error) after
initialization
560R100
BM message timeout error
during operation ready in the
Withdrawal Ready .
1. Operate to initialize BRM(Recovery)
2. Reboot the system when same error
occurred (message timeout error) after
initialization
560R200
BM message timeout error
during transaction operation in
the Withdrawal Ready .
1. Operate to initialize BRM(Recovery)
2. Reboot the system when same error
occurred (message timeout error) after
initialization
560R300
BM message timeout error
during postprocessing to
Withdrawal Ready Error.
1. Operate to initialize BRM(Recovery)
2. Reboot the system when same error
occurred (message timeout error) after
initialization
560RJ00
BM message timeout error
druing Stop Ready in the
Withdrawal Ready.
1. Operate to initialize BRM(Recovery)
2. Reboot the system when same error
occurred (message timeout error) after
initialization
5611100
GS101 sensor jam during
Withdrawal Ready.
1. Open the lower unit
2. Open the Mid Transport Path
3. Remove the recycle cassette (A)
4. Put down the Stage after open the
recycle cassette door (A)
5. Remove notes and substance using
jam removal Knob in the upper side
6. Check whether the sensor is
contaminated or not if there are No
notes or substance