Chapter4. Cash & Check In Module Error Code Manual
© 2014
Nautilus Hyosung Inc.
All Rights Reserved.
4-171
Code
Problem Description
Troubleshooting
I6893
[Deposit Cancel]Failure to check
the last note at the termination of
mid transport path while
retracting those.
1. Execute CCIM initialization.
2. Reboot the system when the same
error occurs after initialization.
I68E0
[Deposit Cancel]Anomaly of check
information
1. Remove the residual media in the
device.
2. Execute initialization.
I68F1
[Deposit Cancel]Internal Error
while the main task is operating.
1. Execute CCIM initialization.
2. Reboot the system when the same
error occurs after initialization.
I68FF
[Deposit Cancel]Failed to move to
3-Way 1 or 3-Way 2 Gate position
1. Open the BM2(7) and BM2(12) and
remove the residual media at the moving
path (7, 8, 9, 10).
2. Execute initialization.
I6B01
[Deposit Cancel]Jam at the BC
entry sensor (BCS01,BCS02).
1. Open the BC cover(3) and remove the
residual media and alien materials.
2. Check the BC Lock state.
I6B02
[Deposit Cancel]Jam at the Align
detection sensor (AAS02).
1. Open the alignment(4) cover and
remove the residual media and alien
materials.
2. Initialize the device.
3. Check the alignment(4) cover lock
state.
I6B03
[Deposit Cancel]Jam at the Align
detection sensor (AAS03).
1. Open the alignment(4) cover and
remove the residual media and alien
materials.
2. Initialize the device.
3. Check the alignment(4) cover lock
state.
I6B04
[Deposit Cancel]Recog detection
sensor (RCS01) jam.
1. Remove the internal media and alien
materials in the Recognition(5).
2. Initialize the device.
3. If the same fault continuously occurs
after checking the device, replace the
Recognition(5) Module.
I6B05
[Deposit Cancel]Jam at the Align
detection sensor (AAS05)
1. After opening the BM2(7) moving
path, open the Alignment(4) Guide2 to
remove media and alien materials.
2. Initialize the device.
9. If the same fault continuously occurs
after checking the device, replace the
Alignment(4) Module.
I6B06
[Deposit Cancel]Jam at the Align
detection sensor (AAS06).
1. Open the alignment(4) cover and
remove the residual media and alien
materials.
2. Initialize the device.
3. Check the alignment(4) cover lock
state.
I6B07
[Deposit Cancel]Jam at Recog exit
moving path sensor (FDS07)
1. Open the BM2(7) Upper Guide and
remove the residual media and alien
material.
2. Open the BM8 moving path to remove
the residual media.