Chapter4. Cash & Check In Module Error Code Manual
© 2014
Nautilus Hyosung Inc.
All Rights Reserved.
4-239
Code
Problem Description
Troubleshooting
I9518
[Retract]Residual media in the
Escrow (ESS01, ESS02) when
preparing for media discharge.
1. Open the Escrow Part(12).
2. Remove the ESS01 and ESS02
media and pollution.
3. Execute CCIM initialization.
I9519
[Retract] Escrow Trigger2
(ESS04) is not detected and
timeout occurs when outputting
the media.
1. Open the Escrow Part(12).
2. Remove the ESS04 media and
pollution.
3. Execute CCIM initialization. 4. Check
the Escrow Drum running motor
(ESM01).
I951A
[Retract] Residual detection
sensor (ESS03) Jam before
Escrow Drum when outputting the
media.
1. Open the Escrow Part(12).
2. Remove the ESS03 media and
pollution.
3. Execute CCIM initialization.
I951B
[Retract]Jam at the Escrow output
check sensor (ESS04) when
outputting the media.
1. Open the Escrow Part(12).
2. Remove the ESS04 media and
pollution.
3. Execute CCIM initialization.
I951C
[Retract]Residual media in the
Escrow (ESS01, ESS02) when
preparing for media discharge.
1. Open the Escrow Part(12).
2. Remove the ESS01 and ESS02
media and pollution.
3. Execute CCIM initialization.
I9520
[Retract]For Escrow Drum winding
(50ms+2591Step), the tape start is
not light-detected for 50ms
continuously, and a fault occurs
when 6s is exceeded.
1. Open the Escrow Part(12).
2. Remove the ESS06 media and
pollution.
3. Check Motor (ESM01)
4. Execute CCIM initialization.
I9521
[Retract]For Escrow Drum winding
(50ms+2591Step), the Drum
motor is not stopped and a fault
occurs when a timeout occurs.
1. Execute CCIM initialization.
2. Reboot the system when the same
error occurs after initialization.
I9522
[Retract]For Escrow Drum winding
(50ms+2591Step), the tape start is
not light-detected for 50ms
continuously, and a fault occurs
when 6s is exceeded.
1. Open the Escrow Part(12).
2. Remove the ESS06 media and
pollution.
3. Check Motor (ESM01)
4. Execute CCIM initialization.
I9523
[Retract]For Escrow Drum winding
(50ms+5730Step), the Drum
motor is not stopped and a fault
occurs when a timeout occurs.
1. Execute CCIM initialization.
2. Reboot the system when the same
error occurs after initialization.
I9524
[Retract]Residual media at the
Escrow entry (ESS03, ESS04)
when detecting tape start (45s) by
unwinding the Escrow Drum
1. Open the Escrow Part(12).
2. Remove the media at the Escrow
Drum residual check (ESS03) and
output check (ESS04) sensor part and
the pollution.
3. Execute CCIM initialization.
I9525
[Retract]When rewinding the
Escrow Drum and detecting the
tape start (45s), the tape start is
not light-detected for 50 ms
continuously and if 45s is
exceeded, a fault occurs.
1. Open the Escrow Part(12).
2. Remove the ESS06 media and
pollution.
3. Check Motor (ESM01)
4. Execute CCIM initialization.