Nautilus Hyosung MX8800, Руководство пользователя, Страница: 770 / 827

Chapter4. Cash & Check In Module Error Code Manual
© 2014 Nautilus Hyosung Inc. All Rights Reserved.
4-217
Code Problem Description Troubleshooting
I852E [Deposit End]The remaining
before the Escrow entry or Drum
is detected (ESS04, ESS03) while
winding the media. 1. Open the Escrow Part(12).
2. Remove the media at the Escrow
Drum residual check (ESS03) and
output check (ESS04) sensor part and
the pollution.
3. Execute CCIM initialization.
I852F [Deposit End]The remaining
before the Escrow entry or Drum
is detected (ESS04, ESS03) while
winding the media. 1. Open the Escrow Part(12).
2. Remove the media at the Escrow
Drum residual check (ESS03) and
output check (ESS04) sensor part and
the pollution.
3. Execute CCIM initialization.
I8530 [Deposit End]The remaining
before the Escrow entry or Drum
is detected (ESS04, ESS03) while
discharging the media. 1. Open the Escrow Part(12).
2. Remove the media at the Escrow
Drum residual check (ESS03) and
output check (ESS04) sensor part and
the pollution.
3. Execute CCIM initialization.
I8531 [Deposit End]The remaining
before the Escrow entry or Drum
is detected (ESS04, ESS03) while
discharging the media. 1. Open the Escrow Part(12).
2. Remove the media at the Escrow
Drum residual check (ESS03) and
output check (ESS04) sensor part and
the pollution.
3. Execute CCIM initialization.
I8580 [Deposit End]Receives a
command which says to unwind
the roll of the Escrow until
exceeding the number of winding
media. 1. Check Sensor (Escrow entry (FDS15)
and output check (EES04) sensor)
2. Execute initialization.
I85F1 [Deposit End]Escrow task force
shutdown. 1. Execute CCIM initialization.
2. Reboot the system when the same
error occurs after initialization.
I8B01 [Retract] Jam at the BC entry
sensor (BCS01,BCS02). 1. Open the BC cover(3) and remove the
residual media and alien materials.
2. Check the BC Lock state.
I8B02 [Deposit End]Jam at the Align
detection sensor (AAS02). 1. Open the alignment(4) cover and
remove the residual media and alien
materials.
2. Initialize the device.
3. Check the alignment(4) cover lock
state.
I8B03 [Deposit End]Jam at the Align
detection sensor (AAS03). 1. Open the alignment(4) cover and
remove the residual media and alien
materials.
2. Initialize the device.
3. Check the alignment(4) cover lock
state.
I8B04 [Deposit End]Recog detection
sensor (RCS01) jam. 1. Remove the internal media and alien
materials in the Recognition(5).
2. Initialize the device.
3. If the same fault continuously occurs
after checking the device, replace the
Recognition(5) Module.