Chapter4. Cash & Check In Module Error Code Manual
© 2014
Nautilus Hyosung Inc.
All Rights Reserved.
4-83
Code
Problem Description
Troubleshooting
I38F1
[Entry In/Out]Internal Error while
the main task is operating.
1. Execute CCIM initialization.
2. Reboot the system when the same
error occurs after initialization.
I38FF
[Entry In/Out] Failed to move to 3-
Way 1 or 3-Way 2 Gate position
1. Open the BM2(7) and BM2(12) and
remove the residual media at the moving
path (7, 8, 9, 10).
2. Execute initialization.
I3B01
[Entry In/Out] Jam at the BC entry
sensor (BCS01,BCS02).
1. Open the BC cover(3) and remove the
residual media and alien materials.
2. Check the BC Lock state.
I3B02
[Entry In/Out] Jam at the Align
detection sensor (AAS02).
1. Open the alignment(4) cover and
remove the residual media and alien
materials.
2. Initialize the device.
3. Check the alignment(4) cover lock
state.
I3B03
[Entry In/Out] Jam at the Align
detection sensor (AAS03).
1. Open the alignment(4) cover and
remove the residual media and alien
materials.
2. Initialize the device.
3. Check the alignment(4) cover lock
state.
I3B04
[Entry In/Out] Jam at the Recog
detection sensor (RCS01).
1. Remove the internal media and alien
materials in the Recognition(5).
2. Initialize the device.
3. If the same fault continuously occurs
after checking the device, replace the
Recognition(5) Module.
I3B05
[Entry In/Out] Jam at the Align
detection sensor (AAS05)
1. After opening the BM2(7) moving
path, open the Alignment(4) Guide2 to
remove media and alien materials.
2. Initialize the device.
6. If the same fault continuously occurs
after checking the device, replace the
Alignment(4) Module.
I3B06
[Entry In/Out] Jam at the Align
detection sensor (AAS06).
1. Open the alignment(4) cover and
remove the residual media and alien
materials.
2. Initialize the device.
3. Check the alignment(4) cover lock
state.
I3B07
[Entry In/Out]Jam at Recog exit
moving path sensor (FDS07)
1. Open the BM2(7) Upper Guide and
remove the residual media and alien
material.
2. Open the BM5 moving path to remove
the residual media.
I3B09
[Entry In/Out]Jam at Recog exit
moving path sensor (FDS07).
1. Open the BM2(7) and then remove
the residual media and alien materials.
2. Check the 3Way-Gate1 operation
state (FDM06)