Chapter4. Cash & Check In Module Error Code Manual
© 2014
Nautilus Hyosung Inc.
All Rights Reserved.
4-45
Code
Problem Description
Troubleshooting
I2308
[Shutter] Billpress moving path
position startup fault
1. Check the inside of the Bundle(1).
2. Remove the alien materials of the
Billpress.
3. If no alien material exists in the
Billpress, check and remove the alien
materials in the Bundle Bill Press home
Position (BDS15) sensor.
4. If no alien material exists, check
whether the sensor is polluted.
I2309
[Shutter] Billpress separation
position startup fault.
1. Check the inside of the Bundle(1).
2. Remove the alien materials of the
Billpress.
3. If the Billpress is up, check whether
the state is BDS18 Dark.
4. If it is not dark, move the P Roller and
check whether the state of BDS18 is
changed.
I230A
[Shutter] Billpress residual position
startup fault.
1. Check the inside of the Bundle(1).
2. Remove the alien materials of the
Billpress.
3. If no alien material exists in the
Billpress, check and remove the alien
materials in the Bundle Bill Press
Up/Down (BDS16) sensor.
4. If no alien material exists, check
whether the sensor is polluted
I230B
[Shutter] Billpress Reject position
startup fault.
1. Check the inside of the Bundle(1).
2. Remove the alien materials of the
Billpress.
3. If no alien material exists in the
Billpress, check and remove the alien
materials in the Bundle Bill Press part
(BDS15, BDS16) sensors.
4. If no alien material exists, check
whether the sensor is polluted
I230D
[Shutter]Media remaining at the
Bundle.
1. Check the inside of the Bundle(1).
2. Remove the notes and alien materials
in the Bundle(1).
3. If no alien material exists, check
whether the sensor in the Bundle(1) is
polluted.
I230F
[Shutter] Sensor fault when
preparing for separation of media.
1. Check the inside of the Bundle(1).
2. Remove the notes and alien materials
in the Bundle entry part (BDS01,
BDS02) sensors.
3. If no alien material exists, check
whether the sensor is polluted
I2312
[Shutter] Fault of receiving media
returned due to low-speed moving
path up.
1. Open the door at the Bundle side and
remove the residual media.
2. Check and remove the alien materials
in the Bundle low-speed wheel position
control (BDS14) sensor.
3. If no alien material exists, check
whether the sensor is polluted
4. Initialize the device.