Chapter4. Cash & Check In Module Error Code Manual
© 2014
Nautilus Hyosung Inc.
All Rights Reserved.
4-9
Code
Problem Description
Troubleshooting
I1206
[Initialize] Fault of causing retry of
moving the Cassette2 Push Plate
Bottom position.
1. Check the jam when moving the push
plate left/right/vertically and manually.
2. Check the Cassette2 push plate
motor (CCM01) running and cable
connection.
I1207
[Initialize]Jam at the sensor
(CCS07) detecting the number of
papers which enter into the
Cassette2.
1. Check residual media or alien
materials at the Cassette2(15) entry and
remove those.
I1208
[Initialize] Fault of causing retry of
moving the Cassette2 Push Plate
top position.
1. Check the arrangement state of the
banknotes in the Cassette2(15).
2. Check the stack position (CCS06) and
the media entry detection (CCS09) prism
state.
3. If the same fault continuously occurs
after checking the device, replace the
Cassette2(15)
I1209
[Initialize] Fault of exceeding the
retries when the Cassette2 Clamp
failed to move to the position
(CCS08 Light).
1. Check the Cassette2 media guide
motor (CCM02) running and cable
connection.
2. If the same fault continuously occurs
after checking the device, replace the
Cassette2(15).
I120A
[Initialize] Fault that the position is
not detected even when the
Cassette2 Clamp is running at the
position (CCS08 Light).
1. Check the Cassette2 media guide
motor (CCM02) running and cable
connection.
2. If the same fault continuously occurs
after checking the device, replace the
Cassette2(15)
I120B
[Initialize] Failure to detect the
bottom (CCS05) when the
Cassette2 Push Plate Stack
moves.
1. Check the arrangement state of
banknotes in the Cassette.
2. Check the Stack position sensor
(CCS06) lever operation state.
3. If the Push Plate is not at the bottom,
check the alien materials at the
Cassette2 Bottom sensor(CCS05).
I1301
[Initialize] Low-speed moving path
sensor fault.
1. Open the door at the Bundle side and
remove the residual media.
2. Check and remove the alien materials
in the Bundle low-speed wheel position
control (BDS14) sensor.
3. If no alien material exists, check
whether the sensor is polluted
4. Initialize the device.
I1302
[Initialize] The delivering roller with
low-speed fails to operate upward.
1. Check whether the Bundle low-speed
moving path (BDM02) is running.
2. Reboot the system when the same
error occurs.
3. Replace the motor and cables when
the same error occurs after checking the
device.