Error Code List Chapter4. Cash & Check In Module
4-76
© 2014
Nautilus Hyosung Inc.
All Rights Reserved.
Code
Problem Description
Troubleshooting
I3580
[Entry In/Out]Receives a
command which says to unwind
the roll of the Escrow until
exceeding the number of winding
media.
1. Check Sensor (Escrow entry (FDS15)
and output check (EES04) sensor)
2. Execute initialization.
I35F1
[Entry In/Out]Escrow Task force
shutdown.
1. Execute CCIM initialization.
2. Reboot the system when the same
error occurs after initialization.
I3602
[Entry In/Out]Batch moving stage
down fail.
1. Check whether the reject batch return
stage down detection (RJS07) sensor is
normally running.
2. Check whether the multiple return
clamp motor (RJM01) is running.
I3603
[Entry In/Out]Batch moving stage
up fail.
1. Check whether the reject batch return
stage up detection (RJS06) sensor is
normally running.
2. Check whether the multiple return
clamp motor (RJM01) is running.
I3604
[Entry In/Out]Batch moving stage
sensor fault.
1. Check whether the reject batch return
stage down detection (RJS07) sensor is
normally running.
2. Check whether the multiple return
clamp motor (RJM01) is running.
I3605
[Entry In/Out]The media at the
reject part is not moved to the
Bundle output check sensor
(RJS09) within a specified time.
1. Reject Door(9) Open
2. Remove the notes and alien materials
in the Reject.
3. If no alien material exists, check
whether the Reject part sensors (RJS01,
RJS02, RJS03, RJS04, RJS05, RJS08,
RJS09) and the sensor (RJS10)
detecting the media residual at the reject
output are polluted.
I3606
[Entry In/Out]After moving the
media at the Reject part to the
Bundle, the media remains at the
Reject part.
1. Reject Door(9) Open
2. Remove the notes and alien materials
in the Reject.
3. If no alien material exists, check
whether the Reject part sensors (RJS01,
RJS02, RJS03, RJS04, RJS05, RJS08,
RJS09) and the sensor (RJS10)
detecting the media residual at the reject
output are polluted.
I3607
[Entry In/Out] Before moving the
media at the Reject to the Bundle,
the billpress of the Bundle part is
not moved to the Reject position.
1. Check the inside of the Bundle(1).
2. Remove the alien materials of the
Billpress.
3. If no alien material exists in the
Billpress,
Check and remove the alien materials
in the Bundle Bill Press part (BDS15,
BDS16) sensors.
4. If no alien material exists, check
whether the sensor is polluted.
I3608
[Entry In/Out]When media are
piled at the Reject part, jam
occurs at the Reject output check
sensor (RJS08).
1. Remove the notes and alien materials
in the Reject output check sensor
(RJS08).
2. If no alien material exists, check
whether the sensor is polluted.