Chapter2. Bill Recycling Machine (BRM) Error Code Manual
© 2014
Nautilus Hyosung Inc.
All Rights Reserved.
2-245
Code
Problem Description
Troubleshooting
57ARB02
Message timeout error for
processing notes remained in
the auto recovery of
Withdrawal.
1. Operate to initialize BRM(Recovery)
2. Reboot the system when same error
occurred (message timeout error) after
initialization
57ARC00
BC response message timeout
error during Withdrawal.
1. Operate to initialize BRM(Recovery)
2. Reboot the system when same error
occurred (message timeout error) after
initialization
57ARJ00
Message timeout error during
Stop Ready during Withdrawal.
1. Operate to initialize BRM(Recovery)
2. Reboot the system when same error
occurred (message timeout error) after
initialization
57AS700
Comparative error when
Withdrawal denomination/note
count set.
1. Operate to initialize BRM(Recovery)
57AS800
Separate count is more than
Remain count when updating
notes count duringduring
Withdrawal.
1. Operate to initialize BRM(Recovery)
57ASR00
Exceed demand for maximum
withdrawal count error during
Withdrawal.
1. Operate to initialize BRM(Recovery)
57ASS00
RC1 is not possible for
Withdrawal .
1. Operate to initialize BRM(Recovery)
57AST00
RC2 is not possible for
Withdrawal.
1. Operate to initialize BRM(Recovery)
57ASU00
RC3 is not possible for
Withdrawal.
1. Operate to initialize BRM(Recovery)
57ASV00
RC4 is not possible for
Withdrawal.
1. Operate to initialize BRM(Recovery)
57ASW00
RC5 is not possible for
Withdrawal.
1. Operate to initialize BRM(Recovery)
57ASX00
Withdrawal demand count
more than relevant CST
remains count in the
Withdrawal.
1. Operate to initialize BRM(Recovery)
57ASY00
Withdrawal demand count is 0
itn the Withdrawal.
1. Operate to initialize BRM(Recovery)
57BH100
RC1 EEPROM read error
during Withdrawal.
1. Check the RC Connector
2. Reload the RC after removing RC
3. Replace the RC if same error occures
during initialization
57BH200
RC2 EEPROM read error
during Withdrawal.
1. Check the RC Connector
2. Reload the RC after removing RC
3. Replace the RC if same error occures
during initialization
57BH300
RC3 EEPROM read error
during Withdrawal.
1. Check the RC Connector
2. Reload the RC after removing RC
3. Replace the RC if same error occures
during initialization
57BH400
RC4 EEPROM read error
during Withdrawal.
1. Check the RC Connector
2. Reload the RC after removing RC
3. Replace the RC if same error occures
during initialization