Chapter4. Cash & Check In Module Error Code Manual
© 2014
Nautilus Hyosung Inc.
All Rights Reserved.
4-17
Code
Problem Description
Troubleshooting
I1512
[Initialize]Jam between the Escrow
entry (ESS04) and (FDS15) when
processing drum full while storing
the media.
1. Open the Escrow Part(12).
2. Remove the media at the Escrow
entry (FDS15) and output check
(ESS04) sensor part and the pollution.
3. Execute CCIM initialization.
I1513
[Initialize]Escrow Tape End
(ESS07) detection fault when
executing media winding.
1. Open the Escrow part (12) and
remove the ESS07 media and pollution.
2. Rotate the Escrow Knob in
counterclock-wise three times.
3. Execute CCIM initialization.
I1514
[Initialize]Escrow Full (ESS05)
detection fault when storing
additional media while terminating
media winding.
1. Open the Escrow part (12) and
remove the ESS05 media and pollution.
2. Rotate the Escrow Knob in
counterclock-wise three times.
3. Execute CCIM initialization.
I1515
[Initialize]Fault of performing a
undefined process flow from
Escrow.
1. Execute CCIM initialization.
2. Reboot the system when the same
error occurs after initialization.
I1516
[Initialize] Residual detection
(ESS03) Jam before Escrow Drum
when outputting the media.
1. Open the Escrow Part(12).
2. Remove the ESS03 media and
pollution.
3. Execute CCIM initialization.
I1517
[Initialize]Light jam at the Escrow
output check sensor (ESS04)
when outputting the media.
1. Open the Escrow Part(12).
2. Remove the ESS04 media and
pollution.
3. Execute CCIM initialization. 4. Check
the Escrow Drum running motor
(ESM01).
I1518
[Initialize]Residual media in the
Escrow (ESS01, ESS02) after
outputting the media.
1. Open the Escrow Part(12).
2. Remove the ESS01 and ESS02
media and pollution.
3. Execute CCIM initialization.
I1519
[Initialize] Escrow Trigger2
(ESS04) is not detected and
timeout occurs when outputting
the media.
1. Open the Escrow Part(12).
2. Remove the ESS04 media and
pollution.
3. Execute CCIM initialization. 4. Check
the Escrow Drum running motor
(ESM01).
I151A
[Initialize] Residual detection
sensor (ESS03) Jam before
Escrow Drum when outputting the
media.
1. Open the Escrow Part(12).
2. Remove the ESS03 media and
pollution.
3. Execute CCIM initialization.
I151B
[Initialize]Escrow output check
sensor (ESS04) jam when
outputting the media.
1. Open the Escrow Part(12).
2. Remove the ESS04 media and
pollution.
3. Execute CCIM initialization.
I151C
[Initialize]Residual media in the
Escrow (ESS01, ESS02) after
outputting the media.
1. Open the Escrow Part(12).
2. Remove the ESS01 and ESS02
media and pollution.
3. Execute CCIM initialization.