Rohde & Schwarz FSV3000, User Manual

Page: 351 / 1489

Common measurement settings
R&S
®
FSVA3000/ R&S
®
FSV3000
351 User Manual 1178.8520.02 ─ 08
1. "Select Measurement"
See Chapter 5, "Measurements and results" , on page 133
2. Input
See Chapter 6.2.2, "Input source settings" , on page 356
3. Amplitude
See Chapter 6.4, "Amplitude and vertical axis configuration" , on page 453
4. Frequency
See Chapter 6.3, "Frequency and span configuration" , on page 446
5. (Optionally:) Trigger/Gate
See Chapter 6.6, "Trigger and gate configuration" , on page 480
6. Bandwidth
See Chapter 6.5.2, "Bandwidth, filter and sweep settings" , on page 470
(For SEM measurements: SEM Setup, see Chapter 5.6.5, "SEM configuration" ,
on page 239)
(For Spurious measurements: Spurious Setup, see
Chapter 5.7.4, "Spurious emis-
sions measurement configuration" , on page 274)
7. (Optionally:) Outputs
See Chapter 6.2.7, "Output settings" , on page 440
8. Analysis
See Chapter 7, "Common analysis and display functions" , on page 502
9. Display
See Chapter 7.1, "Result display configuration" , on page 502
To configure settings
► Select any button to open the corresponding dialog box.
Select a setting in the channel bar (at the top of the channel tab) to change a spe-
cific setting.
Preset Channel
Select the "Preset Channel" button in the lower left-hand corner of the "Overview" to
restore all measurement settings
in the current channel to their default values.
Note: Do not confuse the "Preset Channel" button with the [Preset] key , which restores
the entire instrument to its default values and thus closes all channels on the
R&S FSV/A (except for the default channel)!
Remote command:
SYSTem:PRESet:CHANnel[:EXEC]
on page 1264
Configuration overview