Rohde & Schwarz FSV3000, User Manual

Page: 925 / 1489

Remote commands
R&S
®
FSVA3000/ R&S
®
FSV3000
925 User Manual 1178.8520.02 ─ 08
//Selects single sweep mode.
INIT;*WAI
//Initiates a new measurement and waits until the sweep has finished.
// Now turn off the carrier signal and repeat the measurement:
INIT;*WAI
//Initiates a new measurement and waits until the sweep has finished.
//---------------Retrieving Results-------------
CALC:MARK:FUNC:POW:RES? CN
//Returns the carrier-to-noise ratio.
12.5.5 Measuring the occupied bandwidth
All remote control commands specific to occupied bandwidth measurements are
described here.
● Configuring the measurement ...............................................................................925
● Programming example: OBW measurement ........................................................ 926
12.5.5.1 Configuring the measurement
The following commands configure measurements of the occupied bandwidth.
Useful commands for occupied bandwidth measurements described elsewhere
Configuring the channel:
●
[SENSe:]POWer:ACHannel:BANDwidth[:CHANnel<ch>]
●
[SENSe:]POWer:ACHannel:PRESet
●
[SENSe:]POWer:ACHannel:PRESet:RLEVel
Defining search limits:
●
CALCulate<n>:MARKer<m>:X:SLIMits[:STATe]
on page 1180
●
CALCulate<n>:MARKer<m>:X:SLIMits:LEFT
on page 1180
●
CALCulate<n>:MARKer<m>:X:SLIMits:RIGHt
on page 1181
Performing the measurement:
●
CALCulate<n>:MARKer<m>:FUNCtion:POWer<sb>:SELect
on page 864
●
CALCulate<n>:MARKer<m>:FUNCtion:POWer<sb>[:STATe]
on page 865
Retrieving results:
●
CALCulate<n>:MARKer<m>:FUNCtion:POWer<sb>:RESult?
on page 862
Remote commands exclusive to occupied bandwidth measurements:
[SENSe:]POWer:BWIDth
................................................................................................ 926
[SENSe:]POWer:BANDwidth
...........................................................................................926
Configuring and performing measurements