Rohde & Schwarz FSV3000, User Manual

Page: 47 / 1489

Getting started
R&S
®
FSVA3000/ R&S
®
FSV3000
47 User Manual 1178.8520.02 ─ 08
2. Plug the AC power cable into a power outlet with ground contact.
The required ratings are listed next to the AC power connector and in the data
sheet.
For details on the connector, refer to Chapter 3.3.2.1, "AC power supply connection
and main power switch" , on page 67.
3.2.6 Switching the instrument on and off
Table 3-1: Overview of power states
Status LED on Power key Position of main power switch
Off
gray
[0]
Standby
orange
[I]
Ready
green
[I]
To switch on the R&S FSV/A
The R&S FSV/A is off but connected to power.
1. Set the switch on the power supply to position [I].
See Chapter 3.3.2.1, "AC power supply connection and main power switch" ,
on page 67.
The LED of the Power key is orange.
See Chapter 3.3.1.1, "Power key" , on page 58.
Note: If the R&S FSV/A was disconnected from power before it was switched off
regularly, it automatically switches back on when the power is reconnected.
Using a LAN-controlled power switch, you can take advantage of this behavior to
switch the device on and off remotely.
2. Press the Power key.
See Table 3-1 .
The LED changes to green.
The R&S
FSV/A boots.
After booting, the instrument is ready for operation.
Warm-up time for OCXO
When the instrument is switched on, the OCXO requires an extended warm-up time
(see data sheet).
To shut down the product
The product is in the ready state.
► Press the [Power] key.
The operating system shuts down. The LED changes to orange.
Preparing for use