Rohde & Schwarz FSV3000, User Manual

Page: 198 / 1489

Measurements and results
R&S
®
FSVA3000/ R&S
®
FSV3000
198 User Manual 1178.8520.02 ─ 08
Remote command:
[SENSe:]POWer:ACHannel:FILTer[:STATe]:GAP<gap>[:AUTO]
on page 895
[SENSe:]POWer:ACHannel:FILTer:ALPHa:GAP<gap>[:AUTO]
on page 895
For manual (asymmetrical) configuration:
[SENSe:]POWer:ACHannel:FILTer[:STATe]:GAP<gap>:MANual:LOWer
on page 906
[SENSe:]POWer:ACHannel:FILTer[:STATe]:GAP<gap>:MANual:UPPer
on page 907
[SENSe:]POWer:ACHannel:FILTer:ALPHa:GAP<gap>:MANual:LOWer
on page 907
[SENSe:]POWer:ACHannel:FILTer:ALPHa:GAP<gap>:MANual:UPPer
on page 908
Limit Checking ← Gap Channel Definition
During an ACLR measurement, the power values can be checked whether they
exceed user-defined or standard-defined limits. A relative or absolute limit can be
defined, or both, for each individual gap channel. Both limit types are considered,
regardless whether the measured levels are absolute or relative values. The check of
both limit values can be activated independently. Furthermore, relative limits can be
defined and activated individually for ACLR or CACLR power levels.
If any active limit value is exceeded, the measured value is displayed in red and
marked by a preceding asterisk in the result table.
Note that in addition to activating limit checking for individual channels, limit checking
must also be activated globally for the MSR ACLR measurement (see
"Limit Checking"
on page 187).
Remote command:
"Automatic (symmetrical) configuration" on page 892
5.3.5.5 MSR channel names
Access : "Overview" > "Select Measurement" > "Channel Power ACLR" > "CP / ACLR
Standard" > "Standard": "Multi-Standard Radio" > "CP / ACLR Config" > "Names" tab
Channel names for all TX, adjacent, and alternate channels are user-definable.
In the "Names" tab, you can define a customized name for each channel in each sub
block. Note that the names are not checked for uniqueness.
Channel power and adjacent-channel power (ACLR) measurement