Rohde & Schwarz FSV3000, User Manual

Page: 892 / 1489

Remote commands
R&S
®
FSVA3000/ R&S
®
FSV3000
892 User Manual 1178.8520.02 ─ 08
Automatic (symmetrical) configuration
The following commands are only available for symmetrical (automatic) configuration
of gap channels (see
[SENSe:]POWer:ACHannel:GAP<gap>:MODE
on page 891).
CALCulate<n>:LIMit<li>:ACPower:GAP<gap>[:AUTO]:ABSolute
........................................ 892
CALCulate<n>:LIMit<li>:ACPower:GAP<gap>[:AUTO]:ABSolute:STATe
.............................. 892
CALCulate<n>:LIMit<li>:ACPower:GAP<gap>[:AUTO]:ACLR[:RELative]
............................. 893
CALCulate<n>:LIMit<li>:ACPower:GAP<gap>[:AUTO]:ACLR[:RELative]:STATe
................... 893
CALCulate<n>:LIMit<li>:ACPower:GAP<gap>[:AUTO][:CACLr][:RELative]
.......................... 894
CALCulate<n>:LIMit<li>:ACPower:GAP<gap>[:AUTO][:CACLr][:RELative]:STATe
................ 894
[SENSe:]POWer:ACHannel:BWIDth:GAP<gap>[:AUTO]
.................................................... 895
[SENSe:]POWer:ACHannel:BANDwidth:GAP<gap>[:AUTO]
...............................................895
[SENSe:]POWer:ACHannel:FILTer:ALPHa:GAP<gap>[:AUTO]
........................................... 895
[SENSe:]POWer:ACHannel:FILTer[:STATe]:GAP<gap>[:AUTO]
.......................................... 895
[SENSe:]POWer:ACHannel:GAP<gap>[:AUTO]:MSIZe
......................................................896
[SENSe:]POWer:ACHannel:SPACing:GAP<gap>[:AUTO]
.................................................. 896
CALCulate<n>:LIMit<li>:ACPower:GAP<gap>[:AUTO]:ABSolute <Limit>[,
<Reserved>]
This command defines the absolute limit of the specified gap (CACLR) channel.
If you define both an absolute limit and a relative limit, the R&S FSV/A uses the lower
value for the limit check.
Suffix:
<n>
.
irrelevant
<li> irrelevant
<gap> 1 | 2
Gap (CACLR) channel number
Parameters:
<Limit> Defines the absolute limit of the specified gap channel.
Default unit: dBm
<Reserved> Ignored.
Example: CALC:LIM:ACP:GAP2:ABS 44.2dBm
CALCulate<n>:LIMit<li>:ACPower:GAP<gap>[:AUTO]:ABSolute:STATe <State>
This command turns the absolute limit check for the specified gap (CACLR) channel on
and off.
You have to activate the general ACLR limit check before using this command with
CALCulate<n>:LIMit<li>:ACPower[:STATe]
.
Suffix:
<n>
.
irrelevant
<li> irrelevant
Configuring and performing measurements