Rohde & Schwarz FSV3000, User Manual

Page: 430 / 1489

Common measurement settings
R&S
®
FSVA3000/ R&S
®
FSV3000
430 User Manual 1178.8520.02 ─ 08
Global activation ..........................................................................................................430
External Frontend Connection State ........................................................................... 430
Frontend Type ............................................................................................................. 430
IP Address/ Computer Name ...................................................................................... 430
FW Update .................................................................................................................. 431
Global activation
If enabled, the R&S FSV/A allows you to configure and connect an external frontend.
The application adapts the available measurement settings to the connected frontend,
for example the available frequency range, reference level and attenuation. If no fron-
tend is configured yet, the configuration settings become available. The channel bar
indicates "Inp: ExtFe".
If disabled, the frontend is disconnected. The application adapts the measurement set-
tings to the common settings supported by the R&S
FSV/A.
Remote command:
[SENSe:]EFRontend[:STATe]
on page 1046
External Frontend Connection State
Connects or disconnects the configured frontend for use in a measurement. Note that
this setting is only available if
Global activation of external frontends is set to "On".
It can take up to 10 seconds to determine that LAN connection failed.
If disabled, the connection to the frontend is deactivated temporarily. A running mea-
surement is aborted, the measurement results are indicated as invalid. The measure-
ment settings for the R&S
FSV/A remain untouched.
Remote command:
[SENSe:]EFRontend<fe>:CONNection[:STATe]
on page 1040
[SENSe:]EFRontend<fe>:CONNection:CSTate?
on page 1042
Frontend Type
Defines the type of frontend to be connected.
Currently, the R&S FSV/A supports the following external frontend types:
●
R&S FE44S
●
R&S FE50DTR
Remote command:
[SENSe:]EFRontend<fe>:CONNection:CONFig
on page 1041
IP Address/ Computer Name
The IP address or computer name of the frontend connected to the R&S FSV/A via
LAN. The IP address and computer name are indicated on the electronic ink display on
the side panel of the frontend.
By default, the TCPIP address is expected. To enter the computer name, toggle the
"123"/"ABC" button to "ABC".
Note: You can change the IP address of the connected frontend directly from the
R&S FSV/A, in the "Network configuration" on page 435.
Remote command:
[SENSe:]EFRontend<fe>:CONNection:CONFig
on page 1041
Data input and output