Rohde & Schwarz FSV3000, User Manual

Page: 949 / 1489

Remote commands
R&S
®
FSVA3000/ R&S
®
FSV3000
949 User Manual 1178.8520.02 ─ 08
Example: CALC:LIM:ESP:VAL 33
Activates manual selection of the limit line and selects the limit
line for P = 33.
CALCulate<n>:LIMit<li>:ESPectrum<sb>:PCLass<pc>:COUNt <NoPowerClasses>
This command sets the number of power classes to be defined.
This command must be executed before any new power class values can be defined
using
CALCulate<n>:LIMit<li>:ESPectrum<sb>:PCLass<pc>:MAXimum
and
CALCulate<n>:LIMit<li>:ESPectrum<sb>:PCLass<pc>:MINimum
.
Suffix:
<n>
.
irrelevant
<li> irrelevant
<sb> 1 to 8
<pc> irrelevant
Parameters:
<NoPowerClasses> 1 to 4
*RST: 1
Example: CALC:LIM:ESP:PCL:COUN 2
Two power classes can be defined.
Manual operation: See "Adding or Removing a Power Class" on page 250
CALCulate<n>:LIMit<li>:ESPectrum<sb>:PCLass<pc>[:EXCLusive] <State>
This command selects the power class used by the measurement if
CALCulate<n>:
LIMit<li>:ESPectrum<sb>:MODE
is set to manual.
Note that:
●
You can only use power classes for which limits are defined.
Suffix:
<n>
.
irrelevant
<li> irrelevant
<sb> 1 to 8
<pc> 1..n
power class
Parameters:
<State> ON | OFF | 1 | 0
*RST:
0
Example: CALC:LIM:ESP:PCL1 ON
Activates the first defined power class.
Manual operation: See "Used Power Classes:" on page 249
Configuring and performing measurements