Rohde & Schwarz FSV3000, User Manual

Page: 805 / 1489

Network operation and remote control
R&S
®
FSVA3000/ R&S
®
FSV3000
805 User Manual 1178.8520.02 ─ 08
The remote commands required to define these settings are described in Chap-
ter 12.10.7, "Configuring the network and remote control" , on page 1327.
Step-by-step instructions are provided in Chapter 11.7, "How to set up a network and
remote control" , on page 823.
● General network settings ...................................................................................... 805
● Remote settings .................................................................................................... 807
● Compatibility settings ............................................................................................ 810
● LAN settings ..........................................................................................................814
● HUMS settings ...................................................................................................... 815
● Remote errors ....................................................................................................... 821
● Returning to manual mode ("Local") ..................................................................... 823
11.6.1 General network settings
Access : [SETUP] > "N Remote" > "Network" tab
The R&S FSV/A can be operated in a local area network (LAN), for example to control
the instrument from a remote PC or use a network printer.
Network settings can only be edited in the firmware if a LAN cable is connected to the
R&S
FSV/A.
You can define the settings for both the 1 Gbit and the (optional) 10 Gbit connectors
individually.
Risk of network problems
All parameters can be edited here; however, beware that changing the computer name
has major effects in a network.
For details, see
Chapter 11.7, "How to set up a network and remote control" ,
on page 823.
Network settings in secure user mode
Be sure to store all network settings before SecureUser Mode is enabled; see Chap-
ter 3.2.15, "Protecting data using the secure user mode" , on page 55.
If the currently stored network settings are not suitable, you must correct them each
time you switch on the R&S
FSV/A in secure user mode, as the settings are not stored
permanently in this case.
Network and remote control settings