Rohde & Schwarz FSV3000, User Manual

Page: 767 / 1489

General instrument setup
R&S
®
FSVA3000/ R&S
®
FSV3000
767 User Manual 1178.8520.02 ─ 08
IP Address or Computer name of Signal Generator
The IP address or computer name of the signal generator connected to the
R&S
FSV/A via LAN.
For tips on how to determine the default computer name, see Chapter 3.3.2.16,
"Device ID" , on page 70, or the signal generator's user documentation.
By default, the IP address is expected. To enter the computer name, toggle the
"123"/"ABC" button to "ABC".
Note: While a connection to a signal generator is established, you cannot change the
connection information.
The IP address / computer name is maintained after a [PRESET], and is transferred
between applications. However, when you switch applications, the control is disabled in
the other applications. Only one application can control a generator at any time.
Exception: The SCPI Recorder maintains control of the generator even if you switch
applications.
Select
"Test Connection" on page 751 to establish a temporary connection from the
R&S FSV/A to the specified signal generator.
If a connection to a signal generator is already configured, the connection data is provi-
ded for information only.
Remote command:
CONFigure:GENerator:IPConnection:ADDRess
on page 1347
123/ABC ← IP Address or Computer name of Signal Generator
By default, the TCPIP address is expected. To enter the computer name, toggle the
"123"/"ABC" button to "ABC".
Password ← IP Address or Computer name of Signal Generator
Enter the password required to operate the connected signal generator.
Connect/Disconnect
The R&S FSV/A attempts to establish a connection to the signal generator, or discon-
nects it.
If an instrument is connected, the following information is displayed:
●
Device type
●
Name and serial number
●
Connection state
Note: While the SCPI Recorder is enabled with generator control, you cannot discon-
nect the generator.
Remote command:
CONFigure:GENerator:CONNection[:STATe]
on page 1346
CONFigure:GENerator:CONNection:CSTate?
on page 1346
Coupling State
Enables or disables coupling between the R&S FSV/A and a connected signal genera-
tor.
Synchronizing measurement channel configuration