Rohde & Schwarz FSV3000, User Manual

Page: 1037 / 1489

Remote commands
R&S
®
FSVA3000/ R&S
®
FSV3000
1037 User Manual 1178.8520.02 ─ 08
INPut<ip>:ATTenuation:PROTection:RESet
This command resets the attenuator and reconnects the RF input with the input mixer
for the R&S
FSV/A after an overload condition occurred and the protection mechanism
intervened. The error status bit (bit 3 in the
STAT:QUES:POW
status register) and the
INPUT OVLD
message in the status bar are cleared.
(See
STATus:QUEStionable:POWer[:EVENt]?
on page 1370 and Chap-
ter 11.2.2.12, "STATus:QUEStionable:POWer register" , on page 787).
The command works only if the overload condition has been eliminated first.
For details on the protection mechanism, see "RF Input Protection" on page 357.
Suffix:
<ip>
.
1 | 2
irrelevant
Example: INP:ATT:PROT:RES
INPut<ip>:CONNector <ConnType>
Determines which connector the input for the measurement is taken from.
Suffix:
<ip>
.
1 | 2
irrelevant
Parameters:
<ConnType> RF
RF input connector
RFPRobe
Active RF probe
*RST:
RF
Example: INP:CONN RF
Selects input from the RF input connector.
Manual operation: See "Input Connector" on page 359
INPut<ip>:COUPling <CouplingType>
This command selects the coupling type of the RF input.
Suffix:
<ip>
.
1 | 2
irrelevant
Parameters:
<CouplingType> AC | DC
AC
AC coupling
Setting basic measurement parameters