Rohde & Schwarz FSV3000, User Manual

Page: 1415 / 1489

Remote commands
R&S
®
FSVA3000/ R&S
®
FSV3000
1415 User Manual 1178.8520.02 ─ 08
Further programming examples for common measurement tasks are described in the
individual measurement chapters, for example:
●
Chapter 12.4.3, "Programming example: performing a sequence of measure-
ments"
, on page 856
●
Chapter 12.8.5.4, "Programming example: using limit lines" , on page 1246
●
Chapter 12.5.3.10, "Programming examples for channel power measurements" ,
on page 916
●
"Programming example: Measuring the carrier-to-noise ratio" on page 924
●
Chapter 12.5.5.2, "Programming example: OBW measurement" , on page 926
●
Chapter 12.5.6.11, "Example: SEM measurement" , on page 959
●
Chapter 12.5.7.7, "Programming example: spurious emissions measurement" ,
on page 974
●
Chapter 12.5.8.7, "Programming example: measuring statistics" , on page 985
●
Chapter 12.5.9.4, "Programming example: time domain power" , on page 996
●
Chapter 12.5.10.5, "Example: measuring the harmonic distortion" , on page 1000
●
Chapter 12.5.11.2, "Programming example: measuring the TOI" , on page 1003
●
Chapter 12.5.12.2, "Example: measuring the AM modulation depth" , on page 1005
●
Chapter 12.5.15.2, "Example: performing a pulse power measurement" ,
on page 1024
●
Chapter 12.8.2.7, "Programming example: configuring a spectrogram" ,
on page 1167
●
"Programming example: working with an external mixer" on page 1068
●
"Programming example for external generator control" on page 1084
● Programming example: performing a basic frequency sweep ............................ 1415
● Service request ................................................................................................... 1418
12.15.1 Programming example: performing a basic frequency sweep
This example demonstrates how to configure and perform a basic frequency sweep
measurement in a remote environment.
This example assumes a signal is measured at 100 MHz, with a maximum power level
of -3 dBm.
Some commands in the following examples may not be necessary as they reflect the
default settings; however, they are included to demonstrate the command usage.
//--------------Preparing the measurement ---------------------
*RST
//Resets the instrument
INIT:CONT OFF
//Selects single sweep mode.
Programming examples