Rohde & Schwarz FSV3000, User Manual

Page: 941 / 1489

Remote commands
R&S
®
FSVA3000/ R&S
®
FSV3000
941 User Manual 1178.8520.02 ─ 08
<ri> 1..n
Selects the SEM range.
<li> 1..n
Power class for which the limit is defined.
Parameters:
<Function> OFF | MAX
Defines the function to be used to determine the relative limit
line stop value
MAX
The maximum of the relative and the absolute level is used as
the limit stop value. Use the
[SENSe:]ESPectrum<sb>:
RANGe<ri>:LIMit<li>:RELative:STOP
and
[SENSe:
]ESPectrum<sb>:RANGe<ri>:LIMit<li>:RELative:
STOP:ABS
commands to define these values.
OFF
No function is used, the relative limit line is defined by a fixed
relative stop value. Use the
[SENSe:]ESPectrum<sb>:
RANGe<ri>:LIMit<li>:RELative:STOP
command to define
this value.
*RST:
OFF
Example: SENSe:ESPectrum:RANGe:LIMit:RELative:STOP:
FUNCtion MAX
For a detailed example see Chapter 12.5.6.11, "Example: SEM
measurement" , on page 959.
Manual operation: See "Rel Limit Start / Stop <n>" on page 244
[SENSe:]ESPectrum<sb>:RANGe<ri>:LIMit<li>:STATe <State>
This command selects the limit check mode for all SEM ranges (<range> is irrelevant).
Suffix:
<sb>
.
1 to 8
<ri> 1..n
Selects the SEM range.
<li> 1..n
Power class for which the limit is defined.
Parameters:
<State> ABSolute | RELative | AND | OR
ABSolute
Checks only the absolute limits defined.
RELative
Checks only the relative limits. Relative limits are defined as rel-
ative to the measured power in the reference range.
Configuring and performing measurements