Rohde & Schwarz FSV3000, User Manual

Page: 1330 / 1489

Remote commands
R&S
®
FSVA3000/ R&S
®
FSV3000
1330 User Manual 1178.8520.02 ─ 08
Manual operation: See "LAN Password" on page 815
SYSTem:REVision:FACTory
Resets the response to the
REV?
query to the factory default value.
For example, after a user string was defined using the
SYSTem:REVision[:STRing]
on page 1376 command. (
REV?
query available for HP emulation only, see
SYSTem:
LANGuage
on page 1375.)
Example: Define the system language:
SYST:LANG '8563E'
Set the response back to factory setting:
SYS:REV:FACT
Query the revision:
REV?
Response:
920528
Usage: Event
Manual operation: See "Resetting the Factory Revision" on page 813
SYSTem:SHIMmediate ONCE
Executes any received remote commands that cause changes to the hardware and
have not been executed yet due to a
SYST:SHIM:STAT OFF
command.
Example: SYST:SHIM:STAT ON
...
SYST:SHIM ONCE
Usage: Event
Manual operation: See "Set Hardware Immediately" on page 810
SYSTem:SHIMmediate:STATe <State>
Determines when the remote commands that change hardware settings on the
R&S
FSV/A are executed.
Regardless of this setting, the firmware automatically sets the hardware when a sweep
is started.
This setting is not changed by the preset function.
Parameters:
<State> ON | OFF | 0 | 1
OFF | 0
Remote commands that cause changes to the hardware are
only executed when the
SYSTem:SHIMmediate ONCE
com-
mand is executed.
Configuring the R&S FSV/A