Remote commands
R&S
®
FSVA3000/ R&S
®
FSV3000
929
User Manual 1178.8520.02 ─ 08
12.5.6.2
Controlling the measurement
The following commands control the measurement itself.
INITiate<n>:ESPectrum
This command initiates a Spectrum Emission Mask measurement.
Suffix:
<n>
.
irrelevant
[SENSe:]SWEep:MODE
<Mode>
This command selects the spurious emission and spectrum emission mask measure-
ments.
You can select other measurements with
●
CALCulate<n>:MARKer<m>:FUNCtion:POWer<sb>[:STATe]
Parameters:
<Mode>
LIST | AUTO | ESPectrum
AUTO
Turns on basic spectrum measurements.
ESPectrum
Turns on spectrum emission mask measurements.
LIST
Turns on spurious emission measurements.
*RST:
AUTO
Example:
SWE:MODE ESP
12.5.6.3
Configuring a multi-sem measurement
In the Spectrum application only, spectrum emissions can be measured for multiple
sub blocks of channels (see
Chapter 5.6.4.5, "SEM with multiple sub blocks ("Multi-
on page 236). Up to 8 sub blocks (with 7 gaps) can be defined. For each sub
block, the familiar configuration settings concerning ranges, limit lines etc. can be
defined in individual tabs (select the sub block using the <sb> suffix in the correspond-
ing commands). In addition, settings on the sub blocks themselves must be configured.
Useful commands for multi-SEM measurements described elsewhere:
●
[SENSe:]ESPectrum<sb>:RANGe<ri>:MLCalc
Remote commands exclusive to multi-SEM measurements
..................................................................................930
...................................................................................930
Configuring and performing measurements
