Rohde & Schwarz FSV3000, User Manual

Page: 755 / 1489

General instrument setup
R&S
®
FSVA3000/ R&S
®
FSV3000
755 User Manual 1178.8520.02 ─ 08
NONE ..........................................................................................................................755
Calibration Frequency RF ........................................................................................... 755
└ Spectrum .......................................................................................................755
└ Frequency ..................................................................................................... 756
Calibration Frequency MW ..........................................................................................756
NONE
Uses the current RF signal at the input, i.e. no calibration signal (default).
Remote command:
DIAGnostic:SERVice:INPut[:SELect]
on page 1295
Calibration Frequency RF
Uses the internal calibration signal as the RF input signal.
Remote command:
DIAGnostic:SERVice:INPut[:SELect]
on page 1295
DIAGnostic:SERVice:INPut:PULSed:CFRequency
on page 1295
Spectrum ← Calibration Frequency RF
Defines whether a broadband or narrowband calibration signal is sent to the RF input.
"Narrowband" Used to calibrate the absolute level of the frontend at 64 MHz.
"Broadband" Used to calibrate the IF filter.
Remote command:
DIAGnostic:SERVice:INPut:RF[:SPECtrum]
on page 1295
Service functions