Rohde & Schwarz FSV3000, User Manual

Page: 974 / 1489

Remote commands
R&S
®
FSVA3000/ R&S
®
FSV3000
974 User Manual 1178.8520.02 ─ 08
Suffix:
<n>
.
Window
Parameters:
<NumberPeaks> Range: 1 to 50
*RST: 25
Example: CALC:PSE:SUBR 10
Sets 10 peaks per range to be stored in the list.
Manual operation: See "Peaks per Range" on page 280
12.5.7.4 Adjusting the X-axis to the range definitions
[SENSe:]LIST:XADJust
Sets the x-axis range for the spurious emission measurement from the start frequency
of the first sweep range to the stop frequency of the last sweep range.
Example: SENS:LIST:XADJ
Usage: Event
12.5.7.5 Performing a spurious measurement
The following commands are required to perform a Spurious measurement:
SENS:SWE:MODE LIST
, see
[SENSe:]SWEep:MODE
on page 929
INITiate<n>[:IMMediate]
on page 861, see Chapter 12.5.1, "Performing mea-
surements" , on page 859
12.5.7.6 Retrieving and saving settings and results
The following commands analyze and retrieve measurement results for Spurious mea-
surements.
Useful commands for spurious emission measurements described elsewhere
●
CALCulate<n>:LIMit<li>:FAIL?
on page 1246
●
TRACe<n>[:DATA]
on page 1162
●
TRACe<n>[:DATA]:MEMory?
on page 1162
●
TRACe<n>[:DATA]:X?
on page 1163
12.5.7.7 Programming example: spurious emissions measurement
In the following example, the Spurious Emissions measurement is configured by defin-
ing ranges and parameters to create the following sweep list.
Configuring and performing measurements