Rohde & Schwarz FSV3000, User Manual

Page: 782 / 1489

Network operation and remote control
R&S
®
FSVA3000/ R&S
®
FSV3000
782 User Manual 1178.8520.02 ─ 08
Bit No. Meaning
6-7 Not used
8
HardCOPy
in progress
This bit is set while the instrument is printing a hardcopy.
9 not used
10 Range completed
This bit is set when a range in the sweep list is completed if "Stop after Sweep" is enabled (see
"Stop After Sweep" on page 277).
11-14 Not used
15 This bit is always 0.
11.2.2.5 STATus:QUEStionable register
The STATus:QUEStionable register contains information on instrument states that do
not meet the specifications.
The
STAT:QUES:SYNC
register is used by the applications and is thus described in the
individual applications' User Manuals.
You can read out the register with
STAT:QUES:COND
or
STAT:QUES:EVEN
.
The
STATus:QUEStionable
register "sums up" the information from all subregisters
(e.g. bit 2 sums up the information for all
STATus:QUEStionable:TIMe
registers).
For some subregisters, there may be separate registers for each active channel. Thus,
if a status bit in the
STATus:QUEStionable
register indicates an error, the error may
have occurred in any of the channel-specific subregisters. In this case, you must check
the subregister of each channel to determine which channel caused the error. By
default, querying the status of a subregister always returns the result for the currently
selected channel.
Table 11-5: Meaning of the bits used in the STATus:QUEStionable register
Bit No. Meaning
0 "EXTended"
This bit indicates further status information not covered by the other status registers in any of
the active channels.
1 Unused
2 "TIMe"
This bit is set if a time error occurs in any of the active channels.
The STATus:QUEStionable:TIMe register provides more information on the error type.
3 "POWer"
This bit is set if the measured power level in any of the active channels is questionable.
The STATus:QUEStionable:POWer register provides more information on the error type.
Status reporting system