Cypress S6J3200 Series, Manual

Page: 1017 / 1355

CHAPTER 27:HyperBus Interface
1016 S6J3200 Series Hardware Manual Document Number: 002-04852 Rev. *G
4.
Registers
This section describes the registers of the HYPERBUSI in detail.
The suffix 'n' in the register name indicates that the register is an instance 'n' of the module.

Registers of the HYPERBUSI
The following registers are available for each instance of the HYPERBUSI.
−
Controller Status Register (HYPERBUSIn_CSR)
−
Interrupt Enable Register (HYPERBUSIn_IEN)
−
Interrupt Status Register (HYPERBUSIn_ISR)
−
Memory Base Address Register 0..1 (HYPERBUSIn_MBR)
−
Memory Configuration Register 0..1 (HYPERBUSIn_MCR)
−
Memory Timing Register 0..1 (HYPERBUSIn_MTR)
−
General Purpose Output Register (HYPERBUSIn_GPOR)
−
Write Protection Register (HYPERBUSIn_WPR)
−
Test Register (HYPERBUSIn_TEST)
PERIPHERAL_NAME HYPERBUSI
ADDRESS_WIDTH 32
ENDIANESS Little
DOCPREFIX HYPERBUSI
MODULE_ID
PPU_NAME PPU_HYPERBUSI
BASEADDRESS
ADDR_BLOCK_SIZE 60
USAGE Register