Cypress S6J3200 Series, Manual

Page: 503 / 1355

CHAPTER 20:Sound Mixer
502 S6J3200 Series Hardware Manual Document Number: 002-04852 Rev. *G
3.1.2.
Mixing Stop
Stopping mixing stops input of all channels. Removing a specific channel from mixing stops input of
that channel. See MXCH under 4.1.
3.1.3.
Fade In
−
This setting sets the initial fade in time. See MXCHFADE1 to 5 under 4.10 to 4.14.
−
Next, initialize the fade state. See MXFADECLR under 4.18.
−
After that, enable fade in. See MXCHFADEEN under 4.16.
Notes:
−
The fade in effect assumes that settings are configured before mixing and applied simultaneously
with the start of mixing. However, they can also be applied while the mixing operation is in
progress. In that case, the fade in process starts immediately.
−
Be sure to initialize the fade state before fade in. Fade in following initialization will perform fade
in control of the fade gain from -96 dB to 0 dB. However, this initialization operation is not
necessarily required for fade in following fade out. This is because fade out causes gain to
become -96 dB.
3.1.4.
Fade Out
Fade out can be applied only after fade in.
First, set the fade out time. See MXCHFADE1 to 5 under 4.10 to 4.14. After that, enable fade out. See
MXCHFADEEN under 4.16.
Notes:
−
The fade out effect assumes that settings are configured before the completion of mixing and
applied simultaneously with the completion of mixing. However, they can also be applied while
the mixing operation is in progress. In that case, the fade out process starts immediately.
−
Be sure to initialize the fade state before fade out. Fade out following initialization will perform
fade out control of the fade gain from 0 dB to -96 dB. However, this initialization operation is not
necessarily required for fade out following fade in. This is because fade in causes gain to become
0 dB.