Cypress S6J3200 Series, Manual

Page: 44 / 1355

CHAPTER 3:Product Description
S6J3200 Series Hardware Manual Document Number: 002-04852 Rev. *G 43
Feature Description
Multi-functional Serial (MFS)
See the platform manual in detail.
5 ports of MFS only support I2C.
Note
− Not all pins support I2C. Only pins which have the I2C I/O characteristics support it. See the datasheet in detail.
The I2C is not designed to be hot swappable.
The availability of chip select function can be seen at Function Digit Table.
Chip Select Input is not supported.
CTS/RTS is not mounted (hardware flow control is not supported for this series.)
WUCR function is not supported for this product.
CAN-FD
Flexible data rate is supported.
16KB/ch of message RAM is available.
The clock output from CAN pre-scaler is supplied to every CAN. ECC error generation function of the
message RAM is not supported for this device. Therefore CAN FD ECC Error Insertion Control Register
(FDFECR) is not writeable.
See the platform manual in detail
Real Time Clock (RTC)
with Auto-calibration
See the platform manual in detail.
DDR High Speed SPI
ch.0: HSSPI as a MCU peripheral
ch.1: HSSPI on graphic subsystem
See the platform manual in detail
HyperBus I/F
ch.0: HyperBus as a MCU peripheral
ch.1: HyperBus on graphic subsystem
ch.2: HyperBus on graphic subsystem
The following register is not supported and cannot be used.
− Controller Status Register (HYPERBUSIn_CSR)
− Interrupt Enable Register (HYPERBUSIn_IEN)
− Interrupt Status Register (HYPERBUSIn_ISR)
− Write Protection Register (HYPERBUSIn_WPR)
− Test Register (HYPERBUSIn_TEST)
GPO signal can only be used for "Internal Control example by GPO" in this product, that is, it can select
using HyperBus of PF or using HyperBus of Graphic Sub System.
See the "HyperBus Interface Port Configuration" of S6J3200 hardware manual in detail.
Stepper Motor Control (SMC) Each channel has 4 motor drivers with high output capability
External Interrupt Capture Unit
(EICU)
See the platform manual in detail.