NXP Semiconductors MWCT101 S Series, Reference Manual

Page: 1161 / 1761

Field Function
Clear FAULTF2 by reading the FMS register while FAULTF2 is set and then writing a 0 to FAULTF2 while
there is no existing fault condition at the corresponding fault input. Writing a 1 to FAULTF2 has no effect.
FAULTF2 bit is also cleared when FAULTF bit is cleared.
If another fault condition is detected at the corresponding fault input before the clearing sequence is
completed, the sequence is reset so FAULTF2 remains set after the clearing sequence is completed for
the earlier fault condition.
NOTE: This field is not supported in every instance. The following table includes only supported
registers.
Field supported in Field not supported in
FTM0_FMS —
FTM1_FMS —
FTM2_FMS —
FTM3_FMS —
— FTM4_FMS
— FTM5_FMS
— FTM6_FMS
— FTM7_FMS
0b - No fault condition was detected at the fault input.
1b - A fault condition was detected at the fault input.
1
FAULTF1
Fault Detection Flag 1
Set by hardware when fault control is enabled, the corresponding fault input is enabled and a fault
condition is detected at the fault input.
Clear FAULTF1 by reading the FMS register while FAULTF1 is set and then writing a 0 to FAULTF1 while
there is no existing fault condition at the corresponding fault input. Writing a 1 to FAULTF1 has no effect.
FAULTF1 bit is also cleared when FAULTF bit is cleared.
If another fault condition is detected at the corresponding fault input before the clearing sequence is
completed, the sequence is reset so FAULTF1 remains set after the clearing sequence is completed for
the earlier fault condition.
0b - No fault condition was detected at the fault input.
1b - A fault condition was detected at the fault input.
0
FAULTF0
Fault Detection Flag 0
Set by hardware when fault control is enabled, the corresponding fault input is enabled and a fault
condition is detected at the fault input.
Clear FAULTF0 by reading the FMS register while FAULTF0 is set and then writing a 0 to FAULTF0 while
there is no existing fault condition at the corresponding fault input. Writing a 1 to FAULTF0 has no effect.
FAULTF0 bit is also cleared when FAULTF bit is cleared.
If another fault condition is detected at the corresponding fault input before the clearing sequence is
completed, the sequence is reset so FAULTF0 remains set after the clearing sequence is completed for
the earlier fault condition.
0b - No fault condition was detected at the fault input.
1b - A fault condition was detected at the fault input.
Chapter 41 FlexTimer Module (FTM)
MWCT101xS Series Reference Manual, Rev. 3, 07/2019
NXP Semiconductors 1161