![background image](http://html.mh-extra.com/html/xerox/workcentre-5335-series/workcentre-5335-series_service-manual_884308143.webp)
BUS Updated 12/2011
07/2011
2-129
WorkCentre 5335 Family Service Documentation
012-903, 012-905
Status Indicator RAPs
Initial Issue
012-903 Paper Remains at Compiler Exit Sensor RAP (LX)
BSD-ON:
BSD 12.16 - Office Finisher LX Transportation
Paper remains on the Compiler Exit Sensor.
Initial Actions
Check the paper path. If no paper is found continue with this RAP.
Clean the sensor.
Procedure
Execute
Component Control
[012-150], Compiler Exit Sensor. Actuate the Compiler Exit Sen-
sor (
PL 23.14
). The display changes.
Y
N
Check the wire between
J8869
pin 2 and
P/J8988
pin 5 for an open or short circuit, or a
loose or damaged connector. The wire is OK.
Y
N
Repair/reconnect as required.
Measure the voltage between
P/J8988
, pins 6 and 4 on the Finisher PWB (
BSD 12.16 -
Office Finisher LX Transportation
). The voltage is approx. +5VDC.
Y
N
Replace the Finisher PWB (
PL 23.16
).
Measure the voltage between
P/J8988
, pin 5 on the Finisher PWB and GND (
BSD 12.16
- Office Finisher LX Transportation
).Actuate the Compiler Exit Sensor. The voltage
changes.
Y
N
Replace the Compiler Exit Sensor (
PL 23.14
).
Replace the Finisher PWB (
PL 23.16
).
If the problem continues, replace the Finisher PWB (
PL 23.16
).
012-905 Compiler Tray No Paper Sensor Static JAM RAP
(LX)
BSD-ON:
BSD 12.19 - Office Finisher LX Tamping & Offset (2 of 2)
Paper remains on the Compiler Tray No Paper Sensor.
Initial Actions
Check the paper path. If no paper is found continue with this RAP.
Clean the sensor.
Procedure
Enter
Component Control
[012-151], Compiler Tray No Paper Sensor. Select Start. Actuate
the Compiler Tray No Paper Sensor. The display changes.
Y
N
Check the wire between
J8880
pin 2 and
P/J8994
pin 2 on the Finisher PWB for an open
or short circuit, or a loose or damaged connector. The wire is OK.
Y
N
Repair/reconnect as required.
Measure the voltage between
P/J8994
pins 3 and 1 on the Finisher PWB (
BSD 12.19 -
Office Finisher LX Tamping & Offset (2 of 2)
. The voltage is approx. +5VDC.
Y
N
Replace the Finisher PWB (
PL 23.16
).
Measure the voltage between
P/J8994
pin 2 on the Finisher PWB and GND (
BSD 12.19
- Office Finisher LX Tamping & Offset (2 of 2)
. Actuate the Compiler Tray No Paper
Sensor. The voltage changes.
Y
N
Replace the Compiler Tray No Paper Sensor (
PL 23.12
).
Replace the Finisher PWB (
PL 23.16
).
If the problem continues, replace the Finisher PWB (
PL 23.16
).