![background image](http://html.mh-extra.com/html/xerox/workcentre-5335-series/workcentre-5335-series_service-manual_8843081218.webp)
BUS Updated 12/2011
07/2011
4-160
WorkCentre 5335 Family Service Documentation
REP 13.17, REP 13.18
Initial Issue
Repairs & Adjustments
Figure 20 Installing the brass bearing and E-ring
13. Install the Compiler Tray screw (1).
14. Install the Eject Cover (
REP 13.9
).
15. Install the Stacker Upper Cover (
REP 13.12
).
16. Install the Stacker Tray (
REP 13.20
).
17. Install the Stacker Lower Cover (
REP 13.11
).
18. Install the Foot Cover (
REP 13.10
).
19. Install the Rear Upper Cover (
REP 13.7
).
20. Install the Front Cover (
REP 13.6
).
21. Dock the Finisher to the IOT (
REP 13.5
).
REP 13.18 Crease Assembly (Office Finisher LX)
Parts List on
PL 23.14
Removal
1.
Switch off the power and disconnect the power cord.
2.
Remove the Crease Assembly (
Figure 1
).
(1) Open the Finisher Front Door.
(2) Remove the Guard.
NOTE: Pull out the Cable Tie to obtain additional slack in the wires.
(3) Disconnect the Cable.
(4) Remove the Thumbscrew.
(5) Pull the Crease Assembly straight out.
Figure 1 Removing the Crease Assembly
Replacement
NOTE: Make sure the Locating Pins (2) are properly engaged (
Figure 2
).
1.
Reverse the removal procedure for replacement.
Guard
Cable Tie
Cable
Thumbscrew
Crease Assembly