![background image](http://html.mh-extra.com/html/xerox/workcentre-5335-series/workcentre-5335-series_service-manual_884308814.webp)
BUS Updated 12/2011
07/2011
2-816
WorkCentre 5335 Family Service Documentation
078-101
Initial Issue
Status Indicator RAPs
078-101 HCF to Feed Out Sensor Fault RAP
BSD-ON:
BSD 8.2 - IOT Paper Transportation
BSD-ON:
BSD 8.4 - Tandem Tray Module Takeaway Drive
The Tray 2 Feed Out Sensor did not come on within the specified time after the start of feed
from Tray 6 (HCF).
Initial Actions
•
Clear any paper jam and switch the power off then on.
•
Check for out-of-spec paper.
•
Check paper path for a foreign object/burr/piece of paper
Procedure
Clear the paper jam. Operate the printer from Tray 2. A 072-101 misfeed occurs.
Y
N
Press the Stop button. Turn ON
Component Control
[077-033] (TM Takeaway Motor).
Does the TM Takeaway Motor rotate?
Y
N
Is the voltage between the TM Takeaway Motor
P/J224
-4/6 (+) and the GND (-)
+24VDC?
Y
N
Go to +24VDC Power RAP.
Turn the power OFF, disconnect the TM Takeaway Motor connector
P/J224
.
Measure the TM Takeaway Motor wire wound resistance.
•
Between the TM Takeaway Motor
P/J224
-2 and
P/J224
-1
•
Between the TM Takeaway Motor
P/J224
-2 and
P/J224
-3
•
Between the TM Takeaway Motor
P/J224
-5 and
P/J224
-4
•
Between the TM Takeaway Motor
P/J224
-5 and
P/J224
-6
Is the resistance approx. 0.85Ohm for each? (When the temperature is 25
°
C)
Y
N
Replace the TM Takeaway Motor (
PL 11.5
)
Measure the resistance between the disconnected TM Takeaway Motor connectors
P/J224
-1/3/4/6 and the Frame. Is the resistance infinite for all?
Y
N
Check the wires of the pins with non-infinite resistance for peeled-off coatings
and short circuits due to pinching.
Check the connection between the Tray Module PWB
P/J554
and the TM Takeaway
Motor
P/J224
for open circuit, short circuit, and poor contact. If no problems are
found, replace the following parts in sequence:
•
Tray Module PWB (
PL 11.13
)
•
MCU PWB (
PL 18.2
)
Check the following:
•
Takeaway Rolls 1 and 2 and 3 for dirt/paper particles/wear/a poor rotation
•
HCF and IOT for a poor docking
•
HCF Transport Belt for poor tension
•
HCF Transport Roll for dirt/paper particles/wear/a poor rotation
•
HCF Takeaway Rolls 1-3 for dirt/ paper particles/wear/a poor rotation
•
HCF Exit Roll for dirt/ paper particles/wear/a poor rotation
•
Drive gears for wear/breakage
•
If the results of the above checks are OK, replace Tray Module PWB (
PL 11.13
).
Go to 072-101 Tray 2 Misfeed RAP.
A
A