BUS Updated 12/2011
07/2011
2-128
WorkCentre 5335 Family Service Documentation
012-700, 012-901
Initial Issue
Status Indicator RAPs
012-700 Punch Box Nearly Full RAP (LX)
BSD-ON:
BSD 12.15 - Office Finisher LX Punch
Punch Box nearly full.
Procedure
Empty the Punch Box and re-insert. If the fault remains, check the circuit of the Punch Box Set
Sensor.
012-901 H-Transport Entrance Sensor Static Jam RAP (LX)
BSD-ON:
BSD 12.14 - Office Finisher LX Horizontal Transportation
Paper remains on the H-Transport Entrance Sensor.
Initial Actions
Check the paper path. If no paper is found continue with this RAP.
Clean the sensor.
Procedure
Execute
Component Control
[012-190], H-Transport Entrance Sensor. Actuate the H-Transport
Entrance Sensor (
PL 23.4
). The display changes.
Y
N
Check the wire between
J8861
pin 2 and
J8897
pin 6 for an open or short circuit, or a
loose or damaged connector. The wire is OK.
Y
N
Repair/reconnect as required.
Measure the voltage between
J8897
, pins 4 and 5 on the Finisher PWB (
BSD 12.14 -
Office Finisher LX Horizontal Transportation
). The voltage is approx. +5VDC.
Y
N
Replace the Finisher PWB (
PL 23.16
).
Measure the voltage between
J8897
, pin 6 on the Finisher PWB and GND
BSD 12.14 -
Office Finisher LX Horizontal Transportation
. Actuate the H-Transport Entrance Sen-
sor. The voltage changes.
Y
N
Replace the H-Transport Entrance Sensor (
PL 23.4
).
Replace the Finisher PWB (
PL 23.16
).
If the problem continues, replace the Finisher PWB (
PL 23.16
).