![background image](http://html.mh-extra.com/html/xerox/workcentre-5335-series/workcentre-5335-series_service-manual_884308072.webp)
BUS Updated 12/2011
07/2011
2-56
WorkCentre 5335 Family Service Documentation
003-968, 003-969
Initial Issue
Status Indicator RAPs
003-968 Punch Position Error RAP
Punch Position Error. It is not possible to punch at the selected location.
Procedure
•
Specify an appropriate punch position, clear Punching or cancel Punch, and execute the
job again.
•
If powering OFF then ON does not resolve the problem, perform the following:
•
Check the connection between the IIT PWB and ESS, MCU all PWBs connected to them
(RAM, Firmware module, EEPROM)
•
Check the sw version of the controller sw - reload Software (
GP 16
)
•
Replace IIT PWB (Switch the EEPROM) (
PL 1.6
).
•
Replace ESS PWB (
PL 35.2
).
003-969 Punch Size Error RAP
BSD-ON:
BSD 34.1 - FAX
The number of slow-scan lines has exceeded the upper limit due to Fax parallel composition,
long- document enlargement, etc.
Procedure
•
Press the Continue button to store as much data as the memory capacity and continue
scanning the next document. Or, press the Cancel button to abort the job.
•
Turn the power OFF then ON. If the problem persists, check the installation of the Page
Memory (
PL 35.2
).
•
If powering OFF then ON does not resolve the problem, perform the following:
•
Disconnect then reconnect the harness between the IIT PWB and ESS, MCU all PWBs
connected to them (RAM, Firmware module, EEPROM)
•
Check the sw version of the controller sw - reload Software (
GP 16
)
•
Replace IIT PWB (Switch the EEPROM) (
PL 1.6
).
•
Replace ESS PWB (
PL 35.2
).