![background image](http://html.mh-extra.com/html/xerox/workcentre-5335-series/workcentre-5335-series_service-manual_884308137.webp)
BUS Updated 12/2011
07/2011
2-123
WorkCentre 5335 Family Service Documentation
012-284, 012-291
Status Indicator RAPs
Initial Issue
Execute
Component Control
[012-050 Set Clamp Clutch ON]. The Set Clamp Clutch ener-
gizes.
Y
N
Select Stop. Check the wires between
P/J8877
pins 1 and 2 on the Set Clamp Clutch and
P/J8983
pins 3 and 4 on the Finisher PWB for an open or short circuit, or loose or dam-
aged connectors
BSD 12.23 - Office Finisher LX Eject Control (2 of 2)
. The wires are
OK.
Y
N
Repair/replace as required.
Measure the voltage between the Finisher PWB P8983-4 (+) and GND (-). The voltage
is approx. +24VDC.
Y
N
Replace the Set Clamp Clutch (
PL 23.11
). If the problem persists, replace the Fin-
isher PWB (
PL 23.16
).
Replace the Finisher PWB (
PL 23.16
).
Replace the Finisher PWB (
PL 23.16
).
012-291 Stapler Failure RAP (LX)
BSD-ON:
BSD 12.21 - Office Finisher LX Staple Control
•
After the Stapler Motor turned On (Forward rotation), the Staple Head Home Sensor did
not switch from Off to On within the specified time.
•
After the Stapler Motor turned On (Reverse rotation), the Staple Head Home Sensor did
not turn On within the specified time.
Initial Actions
Check the Stapler for jammed staples or an incorrectly installed staple cartridge.
Procedure
Execute
Component Control
[012-046], Staple Motor FWD, and [012-047], Staple Motor REV.
The Stapler cycles.
Y
N
Check the wires between
J8887
, pins 1~4 on the Stapler Assembly and
P/J8981
pins
9~12 on the Finisher PWB for an open or short circuit, or loose or damaged connectors. If
the wires are OK, the Stapler Assembly (
PL 23.8
). If the problem continues, replace the
Finisher PWB (
PL 23.16
).
Select Stop. Execute [012-244], Staple Home Sensor. The display is “Low.”
Y
N
There is +5 VDC from pin 5 to pin 1 of
J8886
on the Stapler Assembly.
Y
N
Check the wires from
P/J8981
, pins 4 and 8, to
J8886
pins 5 and 1 for an open cir-
cuit. If the wires are OK, replace the Finisher PWB (
PL 23.16
).
Check the wire from
J8886
pin 4 to
P/J8981
pin 5 for an open circuit. If the wire is OK,
replace the Stapler Assembly (
PL 23.8
).
Go to
BSD 12.21 - Office Finisher LX Staple Control
Check for an intermittent connection. If
the check is good, replace the Stapler Assembly (
PL 23.8
). If the problem continues, replace
the Finisher PWB (
PL 23.16
).
A