![background image](http://html.mh-extra.com/html/xerox/workcentre-5335-series/workcentre-5335-series_service-manual_8843081153.webp)
BUS Updated 12/2011
07/2011
4-93
WorkCentre 5335 Family Service Documentation
REP 10.12
Repairs & Adjustments
Initial Issue
NOTE: Support the Left Hand Cover Assembly when releasing the supports to prevent damag-
ing the cover.
4.
Remove the Left Hand Cover Assembly (
Figure 2
).
a.
Twist the Front Support and remove it from the slot.
b.
Remove the K-Clip, and remove the Rear Support from the pin.
c.
Move the cover down to a horizontal position, then lift it off the pivots.
Figure 2 Left Hand Cover Removal
NOTE: Support the Registration Transport when removing it to avoid damaging the wire har-
ness connectors.
5.
Perform the following (
Figure 3
).
a.
Remove the transport Screws (2).
b.
Move the Front of the transport out of the slot and move the transport out.
Figure 3 Removing Screws
6.
Remove the Registration Transport (
Figure 4
).
a.
Release the wires from the clamps.
b.
Disconnect the Registration Transport PJ’s (2), and remove the transport.
Figure 4 PJ’s
Replacement
1.
To install, carry out the removal steps in reverse order.
a
b
c
a
b
a
b