![background image](http://html.mh-extra.com/html/xerox/workcentre-5335-series/workcentre-5335-series_service-manual_884308065.webp)
BUS Updated 12/2011
07/2011
2-49
WorkCentre 5335 Family Service Documentation
003-941, 003-942
Status Indicator RAPs
Initial Issue
003-941 Page Memory Insufficient RAP
A shortage of page memory. There is not enough page memory to store the image.
Procedure
•
Change the parameter(s) and operate again.
•
If the problem persists, check that the Page Memory (
PL 35.2
) is installed and turn OFF
then ON the power.
•
Disconnect then reconnect the ESS, MCU all PWBs connected to them (RAM, Firmware
module, EEPROM)
•
Check the sw version of the controller sw - reload Software (
GP 16
)
•
Reseat/Replace Page Memory (
PL 35.2
).
003-942 Document Size Auto Detect RAP
BSD-ON:
BSD 5.2 - Document Size Sensing (1 of 2)
The document size cannot be automatically detected.
Initial Actions
•
If the document in question is a non-standard size, ask customer to manually set the doc-
ument size. If the fault occurs with standard size documents, continue with the procedure.
•
Check fault history for occurrences of
005-194
,
005-196
, or
005-197
faults. Troubleshoot
any of these faults first.
•
Disconnect then reconnect the ESS, MCU all PWBs connected to them (RAM, Firmware
module, EEPROM)
•
Check the sw version of the controller sw - reload Software (
GP 16
)
Procedure
Execute
Component Control
[005-221]. Block and unblock the DADF Tray Size 1 Sensor. The
display changes.
Y
N
Check the wires between
P/J756
and
P/J761
for an open or shorted circuit or a dam-
aged or loose connector. The wires are OK.
Y
N
Repair as required.
There is approx. +5VDC between
P/J756
pin 3 on the DADF PWB and GND.
Y
N
Replace the DADF PWB (
PL 51.2
).
Measure the voltage between
P/J756
pin 2 on the DADF PWB and GND (-). Block and
unblock the DADF Tray Size 1 Sensor. The voltage changes.
Y
N
Replace the DADF Tray Size 1 Sensor (
PL 51.10
).
Replace the DADF PWB (
PL 51.2
).
Execute
Component Control
[005-222]. Block and unblock the DADF Tray Size 2 Sensor. The
display changes.
Y
N
Check the wires between
P/J756
and
P/J764
for an open or shorted circuit or a dam-
aged or loose connector. The wires are OK.
Y
N
Repair as required.
Measure the voltage between the DADF PWB
P/J756
-6 (+) and GND (-). The voltage is
approx. +5VDC.
Y
N
Replace the DADF PWB (
PL 51.2
).
Measure the voltage between the DADF PWB
P/J756
-5 (+) and GND (-). Actuate the
DADF Tray Size 2 Sensor with paper. The voltage changes.
A